Abstract:A duplex TiC and γ′-Ni3(Al,Ti) reinforced nickel composite was fabricated through hot-press sintering a 30 vol% Ti2AlC–Ni mixtures followed by thermal treatment method. Detailed microstructural detection was performed by adopting the route of high-resolution transmission electron microscopy. In situ generated submicron TiC particulate and nanosized L12-γ′ were homogeneously distributed in a fcc γ-Ni matrix. The high temperature tensile and compression behaviors of the TiC-γ′/Ni composites were evaluated in the temperature range of 25–800 °C. The results indicated that ultimate tensile and compression properties exhibited the dependence of temperatures. The tensile properties of the composite determined at 600 °C was 945 MPa, decreasing by 28.1% and 23.0% for elongation, compared to those of measured at room temperature (UTS = 1305 MPa, elongation = 5.35%). However, the yield strength exhibited the temperature independent until to 600 °C. The yield strength of the TiC-γ′/Ni composite are comparable with conventional superalloy under 600 °C, proving that TiC and γ′ particles constitute efficient reinforcements for Ni matrix according to thermal expansion dislocations strengthening, load-transfer and coherent strengthening mechanisms. The monotonic temperature dependence of yield strength at 600–800 °C indicates that plastic deformation of TiC-γ′/Ni composite follows the thermally activated mechanism. The TiC-γ′/Ni composite exhibited superior mechanical properties both at room and high temperatures, which can be ascribed to the synergistic strengthening effect in term of dislocation density, Orowan, coherent and atomic ordering strengthening mechanisms. The present work reveals the deformation behaviors of in situ TiC-γ′/Ni composite from room to high temperatures, which is critical to predict the failure and thereby optimize the microstructure to further enhance the high temperature properties of TiC-γ′/Ni composite.

Tensile Properties and Fracture Behavior of In-Situ Synthesized Ti 2 AlN/Ti48Al2Cr2Nb Composites at Room and Elevated Temperatures

High Temperature Tensile Properties of in Situ TiBw/Ti6Al4V Composites with a Novel Network Reinforcement Architecture

In Situ Ti2AlN Reinforced TiAl-based Composite with a Novel Network Structure: Microstructure and Flexural Property at Elevated Temperatures

Fabrication and Mechanical Properties of in Situ Synthesized Ti 2 AlN/TiAl Composite

Microstructure and tensile properties of in situ synthesized (TiC + TiB + Nd2O3)/Ti-alloy composites at elevated temperature

Effects of stress state, strain rate, and temperature on fracture behavior of in situ TiB2/2024 Al composite

High Temperature Micromechanical Behavior of Ti2AlN Particle Reinforced TiAl Based Composites Investigated by In-Situ High-Energy X-ray Diffraction

Room Temperature and High Temperature Tensile Properties of in situ Synthesized(TiB+TiC)/Ti-6Al-4V Composites

Microstructure and Mechanical Properties at Both Room and High Temperature of In-Situ TiC Reinforced Al–4.5Cu Matrix Nanocomposite

Microstructure Stability of Ti2AlN/Ti–48Al–2Cr–2Nb Composite at 900 °C

Mechanical Properties and Microstructure of in Situ Formed Ti2AlN/TiAl(WMS)composites

Microstructure and High-Temperature Mechanical Properties of CrMnFeCoNi/TiAl Composites Prepared by Powder Metallurgy

Microstructure and Elevated-Temperature Mechanical Properties of in Situ Ti2AlNb-reinforced TiAl-matrix Composite Prepared by Powder Metallurgy

Investigation on High Temperature Mechanical Behaviors of TiC-γ′ Reinforced Ni Composite

Temperature dependence of fracture behavior of in situ synthesized TiC/Ti-alloy matrix composite

High-temperature tensile strengths of in situ synthesized TiC/Ti-alloy composites

Tensile Properties of in Situ Synthesized Titanium Matrix Composites Reinforced by TiB and Nd2O3 at Elevated Temperature

Hot-Tensile Properties of In Situ Synthesized Multiple-Reinforced (TiB+TiC+Nd2O3)/Ti-Alloy Composites

Investigation on the High-Temperature Ductility and Fracture Mechanisms of an In-Situ Particle Reinforced Al Matrix Composite 7075Al/tib2

Microstructure and Mechanical Properties of Ti2AlC Particle and In-Situ TiAl3 Reinforced Pure Al Composites

Mechanical Properties and Fracture Morphology of In-situ TiB2 Particle Reinforced Aluminum Matrix Composites