Abstract:The evolution of the microstructure of P92 steel during heat processing has a significant effect on the final performance of steel products and is thus an area of critical interest. Accordingly, the grain growth behavior of austenite and δ-ferrite changes in P92 steel is comprehensively investigated in this study through thermodynamic calculations and physical simulation. The results show that the AC1, AC3 and γ–δ transformation temperatures of P92 steel are 841 °C, 878 °C and 1095 °C, respectively, which are comparable to the measured values of 850 °C, 879 °C and 1175 °C, respectively. When the temperature exceeds the AC1 temperature, the austenite grain size increases with increasing temperature and longer holding times, and the growth rate of austenite grains increases with higher temperatures but decreases with holding time at a certain temperature. A model that shows the austenite grain growth kinetics is established: Dn − D 0 n = 2.03 × 1016exp(− 498,770/RT)t, in which the time exponent n decreases from 4.52 to 2.11 with an increase in temperature from 1000 °C to 1200 °C due to the reduced pinning effect resultant of the dissolution of precipitates, M23C6, VX and NbX at 887 °C, 1073 °C and 1200 °C, respectively. The formation of δ-ferrite at 1200 °C when held for 600 s and 1300 °C when held for 60 ~ 600 s causes a smaller austenite grain size. The relationship between the evolution of the microstructure of P92 steel and the mechanical properties is also studied. The results show that the prior austenite grain size has an inverse relationship with impact energy and ultimate tensile strength at 620 °C, while the presence of soft δ-ferrite leads to a reduction in the microhardness, impact energy and ultimate tensile strength at 620 °C.

Precipitate Formations with Self-Adaptive Elemental Diffusion and Segregation in T92 Steel

The Nature of Nano-Sized Precipitates in Ferritic/martensitic Steel P92 Produced by Thermomechanical Treatment

Discontinuous Precipitation During Isothermal Transformation in a 9–12% Chromium Ferritic Steel

Precipitation and Coarsening of Laves Phases in T92 Steels in the Process of Creep

Hierarchical Cu Precipitation in Lamellated Steel after Multistage Heat Treatment

Evolution of Precipitates in Thermomechanically Strengthened P92 Steel under Fe Ion Irradiation at 400 °C

Segregation of S precipitates at T/Al interfaces and relevant effects on localized corrosion mechanisms in Al-Cu-Mg alloy

Polymorphic transformation and elemental diffusional controlled phase spheroidization of eutectic VNbTiSi medium entropy alloy during heat treatment

Interface segregation behavior in thermal aged austenitic precipitation strengthened stainless steel

Precipitate Phases in Normalized Ferritic/Martensitic Steel P92

Coarsening Transitional Kinetics of Γ′ Precipitates in a Nickel-Based Single Crystal Superalloy During Thermal Exposure

Study on Diversified Carbide Precipitation in High‐Strength Low‐Alloy Steel during Tempering

An Extraordinary Reversed Austenite Transformation Behavior in a Cu-Rich Medium Manganese Steel

On the phase stability of MARM247LC alloy during long term thermal exposure

Solidification Segregation Behavior and Homogenization Process of a Difficult-to-Deform Superalloy Used at 850 °C

Evolution of Precipitate Phases in Ferritic and Martensitic Steel P92 During Normalizing and Tempering

Study on Micro Segregation of High Alloy Fe–Mn–C–Al Steel

Characterization of Precipitates in X12CrMoWVNbN10-1-1 Steel During Heat Treatment

High-temperature oxidation behavior and subsurface phase transformation of high-Mn high-Al steel

Investigation on Microstructural Evolutions and Mechanical Properties of P92 Steel During Thermal Processing

Precipitate phases in ferritic/martensitic steel P92 after thermomechanical treatment