Abstract:Large beam-anode layer ion source can produce high-density ions, and has been widely used in plasma cleaning and assisted deposition. However, when increasing the ion-beams, arcing always occurs inside the ion source and serious etching will take place on the cathode which results in sample pollution especially in long-time cleaning. This work proposes two designed structures, called magnetic shields surrounding the anode and sputtering shields on the top of the inner and outer cathodes, respectively. The influence of the designed structure on the electromagnetic field and the plasma properties of the ion source are studied by a self-established simulation techniques based on the particle-in-cell/Monte Carlo collision method and test particle Monte Carlo method. The results show that the magnetic shields surrounding the anode cut off the magnetic induction line between the cathode and anode, which eliminates the arcing condition in the ion source. The sputtering shields for the cathodes use alumina ceramics because of the extremely low sputtering yield and high insulation performance. Therefore, the sputtering shields can not only resist the ion sputtering, but also shield the electric field on the outer surface of the cathode. As a result, the plasma discharge region is compressed towards the anode and away from the cathode simultaneously, which provides a stronger electric field force directed to the output region for Ar+ ions, also resulting in a suppressed cathode etching behavior but an improved Ar+ ion output efficiency. The optimized calculation shows that the best distance from the sputtering shields to the cathode surface is 9 mm. The discharge experiments reveal that the modified ion source can eliminate the inside arcing and provide a clean and strong ion beam with a high efficiency. At the same discharge current, the output efficiency of the modified ion source is 36% higher than that of the original ion source. When used in the plasma cleaning, the glass substrate remains transparent and keeps the original element composition ratio. The detected Fe content, comes from the cathode sputtering, is only 0.03% after the plasma cleaning for 1 h, which is 2 orders of magnitude smaller than that cleaned by the original ion source. The Fe content of the modified ion source is about 0.6% of the original ion source, which is in good agreement with the result of simulation optimization.

Oxide Coated Cathode Plasma Source of Linear Magnetized Plasma Device

Generation of Large-volume Plasma Under Low Air-pressure and Study of Its Electrical Characteristics

Development and Optimization of Step-A Linear Plasma Device for Plasma-Material Interaction Studies

A dc plasma source for plasma–material interaction experiments

Design of a Low Temperature Plasma Generator

Design And Investigation Of A Microwave Plasma Cathode

Coaxial tungsten hot plate-based cathode source for Cesium plasma production confined in MPD device

Effects of Gas Pressure and Discharge Current on Beam Composition in a Magnetron Discharge Ion Source.

Enhanced Discharge of High P Ower Pulsed Magnetron Sputtering Coupling with High Voltage

Design and fabrication of a magnetic filter source to produce ionospheric-like plasma

The first plasma in a newly constructed linear device for plasma turbulence research

Characteristics of a Source for Oxide Coating Deposition by the Electron-Beam Evaporation of Dielectric Materials

Hollow Cathode Vacuum Arc Plasma Electron Source for the Generation of a High-Current DC Electron Beam

Characteristic and Application Study of Multi-Cathodes Metal Plasma Source

High Duty, Long Lifetime, Cathodic Arc Plasma Source

Easy to assemble dielectric barrier discharge plasma ionization source based on printed circuit boards

The Effect of Plasma Activation of Reactive Gas in Reactive Magnetron Sputtering

High Brightness and Density Plasma Source by Novel Capsule Theta Pinch

Development of a Minimizable Pulsed Plasma Source with Structure Induced Focusability

Study and Elimination of the Cathode Etching on Large Beam-Anode Layer Ion Source

Simulation Study on Plasma Discharge and Transport in Cylindrical Cathode Controlled by Expanding Electromagnetic Field