Abstract:A new combustion mode namely multiple premixed compression ignition (MPCI) for gasoline engines was proposed. The MPCI mode can be realized by two or more times gasoline injections into cylinder with a high pressure around the compression TDC and featured with a premixed combustion after each injection in the cylinder, which is different from the existed gasoline direct injection compression ignition (GDICI) modes such as homogeneous charge compression ignition (HCCI) mode with gasoline injection occurred in intake stroke, and partially premixed compression ignition (PPCI) mode with multiple gasoline injections in intake and compression strokes before the start of combustion (SOC). Therefore the spray and combustion of the MPCI mode are alternatively occurred as "spray-combustion-spray-combustion" near the TDC, rather than "spray-spray-combustion" sequence as traditional PPCI gasoline engines. Since the combustion process of the MPCI mode is mainly controlled by the multiple gasoline injections, the SOC and pressure rise rate (PRR) can be controlled easily and effectively through injection timing, injection split ratio and number of the injections. It is expected that each premixed combustion process in the MPCI engine can be realized in the center of combustion chamber with pure air filling the gap between the combustion area and the cylinder wall, resulting in not only the low PM and NOx emissions, but also the low THC and CO emissions while remaining the high thermal efficiency. The experimental study for the MPCI gasoline engine is carried out on a single cylinder compression ignition engine retrofitted from a four-cylinder light-duty diesel engine with the compression ratio of 18.5. A stable and moderate two-stage gasoline MPCI mode is achieved under the running conditions of 0.8 MPa IMEP load and 1400r/min speed at 70 °C intake temperature without EGR and intake boosting using the gasoline fuel with the research octane number of 94.4. The NO and soot emissions as well as THC and CO are relatively low, while keeping the indicated thermal efficiency around 40%, which cannot be easily reached with even diesel fuel under the same conditions. However, optimization for the gasoline MPCI combustion mode is still needed in order to improve the fuel efficiency further. The test results show that the MPCI mode is a promising and feasible combustion mode for gasoline engines achieving both of the high efficiency and low emissions especially at high load. Copyright © 2012 SAE International.

Exploiting new combustion regime using multiple premixed compression ignition (MPCI) fueled with gasoline/diesel/PODE (GDP)

High efficiency and low pollutants combustion: Gasoline multiple premixed compression ignition (MPCI)

Fuel Octane Effects on Gasoline Multiple Premixed Compression Ignition (MPCI) Mode

Gasoline multiple premixed compression ignition (MPCI): Controllable, high efficiency and clean combustion mode in direct injection engines

Comparative Study of Low Octane Gasoline Multiple Premixed Compression Ignition and Conventional Diesel Combustion

Combustion and Emission Characteristics of Multiple Premixed Compression Ignition (MPCI) Fuelled with Naphtha and Gasoline in Wide Load Range

Temporally and Spatially Distributed Combustion in Low-Octane Gasoline Multiple Premixed Compression Ignition Mode

New premixed compression ignition concept for direct injection IC engines fueled with straight-run naphtha

Combustion and Emission Characteristics of Multiple Premixed Compression Ignition (MPCI) Mode with Low Octane Gasoline Fuels

Numerical resolution of multiple premixed compression ignition (MPCI) mode and partially premixed compression ignition (PPCI) mode for low octane gasoline

Effect of Injection Timing on PPCI and MPCI Mode Fueled with Straight-Run Naphtha

Optical Study on Multi-Time Ignition Mixed-Mode Combustion with Gasoline and Pode

Effects of PODE substitution rate and fuel injection timing on combustion, emission characteristic and energy balance in PODE-gasoline dual direct-injection engine

Improvement of Emission Characteristics and Thermal Efficiency in Diesel Engines by Fueling Gasoline/Diesel/Poden Blends

Injection Strategy Optimization for a Multiple Premixed Compression Ignition Engine Based on Taguchi Method

Numerical Investigation of the Effect of Injection Timing on the In-Cylinder Activity of a Gasoline Direct Injection Engine

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Gasoline Compression Ignition (GCI) Combustion in a Light-Duty Engine Using Double Injection Strategy

Effects of different injection strategies on mixing, combustion and emission behavior of gasoline compression ignition (GCI) engines

An experimental investigation on thermal efficiency of a compression ignition engine fueled with five gasoline-like fuels

Effects and mechanism of pilot diesel injection strategies on combustion and emissions of natural gas engine