Abstract:There have been many research reports on the reinforcement of small-sized square columns with a cross-section of 200mm-300mm using prestressed carbon fiber-reinforced polymer (CFRP) materials, while there are few studies on piers in bridge and tower columns in cable-stayed bridges with a cross-section of several meters or even tens of meters. The horizontal prestressed steel tendons in the anchorage zone of tower columns in cable-stayed bridge replaced by prestressed CFRP sheets can not only facilitate construction and maintenance, but also have good fatigue resistance. The prestressed CFRP plate is used to reinforce the large-sized tower columns by using a specific device to tension the CFRP plate wrapped around the surface of the members. The tensioning device and test pedestal based on WSGG (wave-shaped-gear-grip) anchor clamping of CFRP plate have been developed in this paper, and the CFRP plate circumferential tensioning tests on the pedestal have been conducted. The test results are as follows: (1) the developed device can achieve circumferential tensioning of single-layer CFRP plate to 0.5ftk of the material, reaching a tensile force of 60kN, and generate effective restraint pressure on a 2-m long composite compression component; (2)The calculation formula for the constraint pressure generated by the circumferential prestressed CFRP sheet on the component has been derived and verified, and the maximum error between the calculated value and the experimental value is within 5%; (3) When iron sheet serves as the interface medium between CFRP plate and compression components, the prestress loss of the CFRP plate tensioned at one end is about 84% and 58%-60% when tensioned at both ends. It can be seen that the effective prestress of the CFRP plate with iron sheet as the interface medium is relatively small. Meanwhile, based on the distribution of compressive stress in the components and the effective pre tension value of CFRP plate, it can be seen that two end tensioning is better than one end tensioning; (4) The tensile stress of CFRP plate along the member is a cubic function when the tension force is 60kN, so it is deduced that the constrained compressive stress generated by CFRP plate on the member is a quadratic function distribution.

Experimental Investigations on Impact Behavior of Cfrp Cables under Pretension

Experimental study on dynamic behavior of CFRP-to-steel interface

Impact Testing of Reinforced Concrete Beams Shear-Strengthened with Fiber-Reinforced Polymer Wraps

Experimental Investigation on Performance of Cantilever CFRP-wrapped Circular RC Columns under Lateral Low-Velocity Impact

Effectiveness of CFRP Seismic-Retrofit of Circular RC Bridge Piers under Vehicular Lateral Impact Loading

Dynamic Behavior of CFRP-Strengthened Reinforced Concrete Beams Without Stirrups under Impact Loading

Cfrp Strip Cable Retrofit of Rc Frame for Collapse Resistance

EXPERIMENTAL STUDY ON FLEXURAL BEHAVIOR OF REINFORCED CONCRETE BEAMS PRE-STRESSED WITH CFRP TENDONS

Tests for anti-shear failure mechanism of CFRP-strengthened RC Beams without Stirrups under impact loading

Dynamic characteristics of CFRP cables under lateral wind load

Experimental Study on Dynamic Behavior of GFRP-to-concrete Interface

THEORETICAL ANALYSIS AND EXPERIMENTAL TEST ON DAMPING CHARACTERISTICS OF CFRP STAY CABLES

Experimental Investigation of Fatigue Capacity of Bending-Anchored CFRP Cables

Experimental and Numerical Study of Corrugated Anchors for CFRP Plates

Effect of sustaining load level on flexural behavior of RC beams retrofitted with CFRP sheets

Static Experimental Study on New Arc Multi-Tendon CFRP Cable Anchorage System

An Experimental Study of Self-anchored Combined CFRP Cables

Experimental study on large-scale compression members strengthened with circumferential prestressed CFRP plate

An Efficient Method for Culturing Human Breast Epithelium: Analysis of Results

Aerodynamic performance and wind-induced response of carbon fiber-reinforced polymer (CFRP) cables

Flexural capacity of concrete beams prestressed with carbon fiber reinforced polymer (CFRP) tendons