Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

Numerical Study of the Scaling Rules for Riser with Consideration of Cluster Effect

Effect Of The Scale-Up Process On The Reactor Performance Within The Riser: Simulation Using Ozone Decomposition

Experimental and Numerical Investigations of Scale-Up Effects on the Hydrodynamics of Slurry Bubble Columns

Eulerian-Lagrangian Simulation of Distinct Clustering Phenomena and Rtds in Riser and Downer

Numerical studies of the influence of particles' size distribution characteristics on the gravity separation performance of Liquid-solid Fluidized Bed Separator

CFD-DEM Simulation of Clustering Phenomena in Riser and Downer

Clustering in Gas-Fluidized Riser Flows of Flexible Fibers

A CFD–DEM study of the cluster behavior in riser and downer reactors

Clusters intermittent simulations using dynamic cluster structure-dependent drag model in gas-particles risers

Investigation of cluster property in the riser of circulating fluidized bed with a wide particle size distribution

A Hydrodynamic Model for Circulating Fluidized Beds with Low Riser and Tall Riser

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Cluster Behavior In Cfb Riser And Downer Simulated By Cfd-Dpm Method

A dynamic cluster structure-dependent drag coefficient model applied to the riser in high density circulating fluidized bed

An Assessment of Drag Models in Eulerian–Eulerian CFD Simulation of Gas–Solid Flow Hydrodynamics in Circulating Fluidized Bed Riser

Improving Solid-Phase Fluidization Prediction in Circulating Fluidized Bed Risers: Drag Model Sensitivity and Turbulence Modeling

Simulation of Dense Gas-particle Flows in a Riser Using a Two-scale Second-order Moment Particle Turbulence Model

Development and Validation of Cluster and EMMS Drag Model

Improvement of EMMS Drag Model for Heterogeneous Gas–solid Flows Based on Cluster Modeling

Numerical study on influence of exit geometry in gas–solid flow hydrodynamics of HDCFB riser by CPFD

Experiment and Numerical Simulation of the Performance on Scaled Compressor Cascade and Development of a Prediction Model