Abstract:A Ni/scandia-stabilized zirconia (ScSZ) cermet anode was modified by coating with nano-sized gadolinium-doped ceria (GDC, Gd0.2Ce0.8O2) prepared using a simple combustion process within the pores of the anode for a solid oxide fuel cell (SOFC) running on methane fuel. X-ray diffraction (XRD) and scanning electron microscopy (SEM) were employed in the anode characterizations. Then, the short-term stability for the cells with the Ni/ScSZ and 2.0wt.%GDC-coated Ni/ScSZ anodes in 97%CH4/3%H2O at 700°C was checked over a relative long period of operation. Open circuit voltages (OCVs) increased from 1.098 to 1.179V, and power densities increased from 224 to 848mWcm−2, as the operating temperature of an SOFC with 2.0wt.%GDC-coated Ni/ScSZ anode was increased from 700 to 850°C in humidified methane. The coating of nano-sized Gd0.2Ce0.8O2 particle within the pores of the porous Ni/ScSZ anode significantly improved the performance of anode supported cells. Electrochemical impedance spectra (EIS) illustrated that the cell with Ni/ScSZ anode exhibited far greater impedances than the cell with 2.0wt.%GDC-coated Ni/ScSZ anode. Introduction of nano-sized GDC particles into the pores of porous Ni/ScSZ anode will result in a substantial increase in the ionic conductivity of the anode and increase the triple phase boundary region expanding the number of sites available for electrochemical activity. No significant degradation in performance has been observed after 84h of cell testing when 2.0wt.%GDC-coated Ni/ScSZ anode was exposed to 97%CH4/3%H2O at 700°C. Very little carbon was detected on the anodes, suggesting that carbon deposition was limited during cell operation. Consequently, the GDC coating on the pores of anode made it possible to have good stability for long-term operation due to low carbon deposition.

MnO-Co Composite Modified Ni-SDC Anode for Intermediate Temperature Solid Oxide Fuel Cells

An in Situ Formed MnO–Co Composite Catalyst Layer over Ni–Ce0.8Sm0.2O2−x Anodes for Direct Methane Solid Oxide Fuel Cells

Anode Performance of Mn-doped Ceria–scsz for Solid Oxide Fuel Cell

Catalytic Modification of Ni–Sm-doped Ceria Anodes with Copper for Direct Utilization of Dry Methane in Low-Temperature Solid Oxide Fuel Cells

A Novel Method to Purposely Modify the Anode/Electrolyte Interface in Solid Oxide Fuel Cells

Gel-cast NiO–SDC Composites As Anodes for Solid Oxide Fuel Cells

Cu-Ce0.8Sm0.2O2-δ anode for electrochemical oxidation of methanol in solid oxide fuel cell: Improved activity by La and Nd doping

A Hierarchical Porous Microstructure for Improving Long-Term Stability of Ni1-Xcux/Sdc Anode-Supported It-Sofcs Fueled with Dry Methane

Boosting Electrochemical Performance of Ho3+and Sm3+co-doped CeO2 Intermediate-Temperature Solid Oxide Membrane Fuel Cells by NiO

Achieve a high electrochemical oxidation activity by a self-assembled cermet composite anode with low Ni content for solid oxide fuel cells

A Regenerative Coking and Sulfur Resistant Composite Anode with Cu Exsolution for Intermediate Temperature Solid Oxide Fuel Cells

Enhanced Coking Resistance of Ni Cermet Anodes for Solid Oxide Fuel Cells Based on Methane On‐cell Reforming by a Redox‐stable Double‐perovskite Sr 2 MoFeO 6‐Δ

Performance Investigation of a Nickel Cermet Anode Modified with Copper, Alkaline Earth Metal Oxide, Boron, and Perovskite for Direct Methane Fuel Cell

Direct-Methane Solid Oxide Fuel Cells with Hierarchically Porous Ni-Based Anode Deposited with Nanocatalyst Layer

Tuning Layer-Structured La0.6sr1.4mno4+Delta Into A Promising Electrode For Intermediate-Temperature Symmetrical Solid Oxide Fuel Cells Through Surface Modification

Preparation and characterization of Sm0.2Ce0.8O1.9/Na2CO3 nanocomposite electrolyte for low-temperature solid oxide fuel cells

Preparation of Porous NiO-Ce0.8Sm0.2O1.9 Ceramics for Anode-supported Low-temperatureSolid Oxide Fuel Cells

Preparation and characterization of Ni-Fe-CCC composite for low-temperature ceramic fuel cell

Development of Trimetallic Ni-Cu-Zn Anode for Low Temperature Solid Oxide Fuel Cells with Composite Electrolyte

Fe Co0.5−Ni0.5–SDC Anodes for Low-Temperature Solid Oxide Fuel Cells

Performance of Ni/Scsz Cermet Anode Modified by Coating with Gd0.2ce0.8o2 for an Sofc Running on Methane Fuel