Abstract:This paper presents a novel decoupled two degrees of freedom (2-DOF) translational parallel micro-positioning stage. The stage consists of a monolithic compliant mechanism driven by two piezoelectric actuators. The end-effector of the stage is connected to the base by four independent kinematic limbs. Two types of compound flexure module are serially connected to provide 2-DOF for each limb. The compound flexure modules and mirror symmetric distribution of the four limbs significantly reduce the input and output cross couplings and the parasitic motions. Based on the stiffness matrix method, static and dynamic models are constructed and optimal design is performed under certain constraints. The finite element analysis results are then given to validate the design model and a prototype of the XY stage is fabricated for performance tests. Open-loop tests show that maximum static and dynamic cross couplings between the two linear motions are below 0.5% and -45 dB, which are low enough to utilize the single-input-single-out control strategies. Finally, according to the identified dynamic model, an inversion-based feedforward controller in conjunction with a proportional-integral-derivative controller is applied to compensate for the nonlinearities and uncertainties. The experimental results show that good positioning and tracking performances are achieved, which verifies the effectiveness of the proposed mechanism and controller design. The resonant frequencies of the loaded stage at 2 kg and 5 kg are 105 Hz and 68 Hz, respectively. Therefore, the performance of the stage is reasonably good in term of a 200 N load capacity.

Design of an Additive Manufactured XY Compliant Manipulator with Spatial Redundant Constraints

Design of a Flexure-Based XY Positioning Stage with Balanced Axial Forces on Decoupling Modules

Design And Analysis Of Two Dimensional X-Y Micropositioning Stage

A Spatial Design of a Large Stroke Compliant XY Nanomanipulator with Cross-Coupling Error Reduction

Design, modeling, analysis and testing of a novel piezo-actuated XY compliant mechanism for large workspace nano-positioning

Design and Analysis of A Large-stroke Multi-layer XY Compliant Nanomanipulator of Linear Stiffness

A Novel Flexure-Based 3-DOF Micro-Parallel Manipulator with a Gripper for Micro/nano Manipulation

Redundantly Piezo-Actuated XYθ Z Compliant Mechanism for Nano-Positioning Featuring Simple Kinematics, Bi-Directional Motion and Enlarged Workspace

A Novel Hybrid Actuation Mechanism Based XY Nanopositioning Stage with Totally Decoupled Kinematics

Design of a New XY Compliant Parallel Manipulator Based on Deployable Spatial Monolithic Structure

A Large Range Flexure-Based Servo System Supporting Precision Additive Manufacturing

An Optimized Design of a Large Stroke Beam Flexure-Based Parallel Nano Manipulator

An Xy Nanopositioner With A Self-Adjusting Stiffness Center Module

A Self-Adjusting Stiffness Center Design for Large Stroke Compliant XY Nanomanipulators

Development of a Large-Range XY-Compliant Micropositioning Stage with Laser-Based Sensing and Active Disturbance Rejection Control

Design and control of a decoupled two degree of freedom translational parallel micro-positioning stage

Hybrid Flexure-Based Multi-Level Mechanism Design Supporting Centimeter Stroke Nano Manipulator

Design, optimization, and characterization of an XY nanopositioning stage with multi-level spatial flexure hinges for high-precision large-stroke motion guidance

Design and Analysis of a New Flexure-Based XY Stage

A Novel Piezoelectrically Actuated 2-Dof Compliant Micro/Nano-Positioning Stage with Multi-Level Amplification

Design and Analysis of a Symmetric Overconstrained Compliant Tilt/Tip Stage Based on a Hybrid Transmission Ratio Model