Abstract:High vacuum multilayer insulation (HV-MLI) cryogenic pipes which are used to transport low-temperature media (e.g.LNG) are often in a cryogenic environment with internal fluid pressure,so they will bear complex loads due to the effect of thermal-structural coupling.For investigating the response of each part in an HV-MLI cryogenic pipe under complex loads,the thermal-structural coupling finite element model was established based on a certain L-shape HV-MLI cryogenic pipe of horizontal-vertical trending.Then,the distribution of pipe temperature fields in different operating conditions,and the stresses on inner tubes,outer tubes,thermal bridges,bellows and thermal insulation supports and their variation in different loads were calculated.The following findings were obtained based on the above mentioned analysis.First,thermal insulation supports and thermal bridges are the main parts that affect heat leakage of pipes.In the case of LN2 transportation,for example,the heat leakage at thermal insulation supports and thermal bridges accounts for about 49.07％ and 49.32％ of the total pipe heat leakage,respectively.Second,inner tubes,outer tubes,elbows and thermal bridges are very safe when they are in service since their stresses are relatively small and lower than the material yield limit.Third,the stress on bellows increases with the decrease of the transportation medium temperature and the increase of compensation inner tube length.The bellow in a horizontal section is the most dangerous part of the whole pipe due to its higher stress.And fourth,the internal pressure on inner tubes is the main factor impacting the stress of thermal insulation supports.With the increase of the internal pressure on inner tubes,the stress on thermal insulation supports in horizontal and vertical pipe sections,which is the closest to the elbow,increases significantly,but the stress on thermal insulation supports,which is far away from the elbow,doesn't change greatly.Therefore,it is necessary to increase the thickness of thermal insulation supports close to the elbow and reduce the thickness of thermal insulation supports far away from the elbow in order to guarantee the strength as well as to reduce heat leakage.

Preliminary study on light liquid insulation material for pipe transmission line

Study of Surface Flashover and Breakdown Characteristics in Liquid Nitrogen for Sfcl Application

Insulation Coordination of UHVDC Transmission Line

Heat Transfer Analysis of Different Conditions for SF$_{6}$/N$_2$ Gas-Insulated Transmission Lines

Liquefied Natural Gas for Superconducting Energy Pipelines: A Feasibility Study on Electrical Insulation

Research progress on environmental-friendly insulating gases for HVDC gas-insulated transmission lines

Feasibility Analysis of Polymeric Material Insulator Applied to Phase to Earth Insulation of Transmission Line

Construction of Cold Insulation for LNG Project

Heat Dissipation Analysis of the CF3I Gas and Its Mixtures Using in Gas Insulated Transmission Line

Conceptual Design and Feasibility Study of Flexible Gas-Insulated Transmission Line Using CF3I Gas Mixture

Research on Insulation Design of UHV Gas-Insulated Metal-Enclosed Transmission Line

Research and Application of UHVAC Gas-Insulated Transmission Line

Application and Development of Gas Insulated Transmission Line (GIL)

Research Status and Prospect of Gas-insulated Metal Enclosed Transmission Line

Analysis of thermal energy storage optimization of thermal insulation material and thermal insulation structure of steam pipe-line

Thermo-structural coupling analysis on L-shape HV-MLI cryogenic pipes

Research on Insulation Reliability of Submarine Cable Accessories for HVDC Transmission Applications

Research on the Structural Performance of Liquid Nitrogen Ice Plugs on Nuclear Power Pipes

Comparative study of three insulation materials installed on type C independent tank for offshore LNG transportation

Life cycle cost approach involving steam transport model for insulation thickness optimization of steam pipes

Thermo-economic Analysis for Directly-buried Pipes Insulation of District Heating Piping Systems☆