Abstract:The special injection manner of magnetically-insulated induction voltage adders (MIVA) leads to the spatially asymmetric distributions of injected currents. It might affect the cavity performances and the characteristics of magnetic insulation in the secondary sides of MIVA, such as the electron sheath, flow impedance, and the current variations. In this paper, a full-size electromagnetic model of an induction cavity was developed, to acquire the spatial distribution of injected currents in the primary sides of cavities and the profiles of magnetic fields in the secondary sides. The dynamic process of the asymmetric coefficient, δ(t), was obtained. Some factors affecting the δ(t) were analyzed in detail, such as the pulse width of injected currents, the insulating medium in the primary sides of cavities, the number of injected pulses and their driver jitter. It is found that, the dynamic process of asymmetric coefficient, δ(t), consists of three phases, i.e., the fast drop process, steady state, and slow decrease process. The pulse width of injected currents affects the duration of the steady state and the subsequent third process. The insulating medium in the primary sides of cavities affects the spatial distributions of injected currents by changing the transmission speed of electrical pulses in cavities. The number of injected pulses has crucial influence on the current distributions. As the two pulses driving the same cavity could not arrive simultaneously, the current distributions would change. Moreover, the current injection experiments of a single-stage cavity in part confirm the simulation results.

Mathematical Derivation of Cell-Driving-Jitter Effects on the Risetime of IVA-Output Voltages

Effects of Cell-Driving Jitters on the Output Voltage of Magnetically Insulated Induction Voltage Adders

Influences of Cell-Driving Sequences on Performances of Magnetically Insulated Induction Voltage Adders

Dynamic Supply Noise Aware Timing Analysis with JIT Machine Learning Integration

Bursty Jitter In High-Speed I/O Due To Power-State Transition And Its Impact On Signal Integrity

An Assessment Of Rtn-Induced Threshold Voltage Jitter

Numerical Simulation of Azimuthal Uniformity of Injection Currents in Single-Point-Feed Induction Voltage Adders

Current Density Distributions on the Cathode Plates of Inductive Voltage Cells

On the efficacy of input Vector Control to mitigate NBTI effects and leakage power

Spatially Asymmetric Distribution and Related Influence Factors of Injected Currents in Magnetically-Insulated Induction Voltage Adders

Simulation Analysis of Transformer Oil and Glycerin As Dielectric Medium in Inductive Voltage Adders

A VDD Correction Method for Static Stability Test of SRAM Bit Cell

An Efficient Optimization Based Method to Evaluate the DRV of SRAM Cells

Influences of Switching Jitter on the Operational Performances of Linear Transformer Drivers-Based Drivers

MAXIMUM LIKELIHOOD ESTIMATION FOR FAILURE ANALYSIS OF SRAM CELLS USING INDUCTIVE FAULT ANALYSIS

New Analysis Method for Time-Dependent Device-To-Device Variation Accounting for Within-Device Fluctuation

NBTI and Power Reduction Using an Input Vector Control and Supply Voltage Assignment Method

Influence factors on the azimuthally uniform feed in single-point feed induction voltage adder

An Analytical Gate Delay Variability Model for Low-Power Applications under the Process Variations Effects

Calculation of the Worst-Case Voltage Noise for a Power Distribution Network Based on Ramp Current

Investigation on NBTI-induced dynamic variability in nanoscale CMOS devices: Modeling, experimental evidence, and impact on circuits.