Abstract:Photocatalytic hydrogen generation by solar energy is a promising approach to clean energy resource and has attracted great attention over the past decades. [1] Perovskites ABO3 structures provide the basic stable framework to both crystal and electronic structures modification, which have found extensive applications in photocatalysis, solar cells and photoelectrochemical (PEC) water splitting. [2] LaFeO3 has a suitable band gap of 2.07eV [3, 4] and exhibits excellent visible light photocatalytic performance. However, the poor charge transport and slow reaction kinetics at the surface [3, 4] are the main factors limiting its further improvement on photocatalytic application. To overcome these obstacles, transition metals (Mn, Co, Cu) are introduced into LaFeO3 and the photocurrent of 10% Cu doped sample is improved by three times than that of LaFeO3. The reduced charge transport resistance owing to the Fe3+ discharge is identified to benefit the PEC performance improvement after TM doping. On the other hand, the surface state of LaFeO3 is modified by electrodepositing of amorphous cobalt-phosphate (Co-Pi). It shows that the presence of Co-Pi down-shifts the onset potential by ~ 560 mV for anodic photocurrent and the improvement can be attributed to the enhanced water oxidation due to the CoII/CoIII-OH discharge on Co-Pi decorated layers. The transition anodic photocurrent is improved by about six times after Co-Pi coating under visible light at 0.50 V vs. Ag/AgCl and the electrochemical impedance spectroscopy certifies the enhanced charge transfer, which contributes to the meliorative anodic photocurrent. The incident photon-to-current conversion efficiencies of LaFeO3 can be promoted from 1.37% to 2.14% at 400 nm after Co-Pi coating. Our results demonstrate that modification of the electronic structure (TM doping) and surface state (Co-Pi coating) are the promising way to promote the photoconversion efficiency of LaFeO3-based PEC cells under visible light. References: X. Lu, S. Xie, H. Yang, Y. Tong, H. Ji, Chem. Soc. Rev., 43, 7581 (2014). Z. G. Yi and J. Ye, Appl. Phys. Lett., 91, 254108 (2007). K. M. Parida, K. H. Reddy, S. Martha, D. P. Das and N. Biswal, Int. J. Hydrogen Energy, 35, 12161 (2010). Q. Peng, B. Shan, Y. Wen and R. Chen, Int. J. Hydrogen Energy, 40, 15423 (2015).

Photocatalytic property of perovskite LaFeO3 synthesized by sol-gel process and vacuum microwave calcination

Preparation of Lanthanum Ferritevia Ultrasound-assisted Sol-gel Method and Its Photocatalytic Activity

Preparation, Characterization and Optical Property of LaFeO3 Nanoparticles via Sol-Gel Combustion Method

Fe-doped LaNi1-xFexO3 perovskite oxides for enhanced visible-light-driven photocatalytic activity

Dye degradation activity and stability of perovskite-type LaCoO 3-x (x = 0∼0.075)

Dye Degradation Activity and Stability of Perovskite-Type LaCoO 3 x ( x 1⁄4 0 0 : 075 )

Dye Degradation Activity and Stability of Perovskite-Type LaCoO<SUB>3&minus;<I>x</I></SUB> (&Lt;i>x</i>=0&sim;0.075)

Photocataltic reduction of CO2 by nanometer LaFeO3-TiO2

Solar-light-driven LaFe x Ni 1− x O 3 perovskite oxides for photocatalytic Fenton-like reaction to degrade organic pollutants

Tailoring the cationic and anionic sites of LaFeO 3 -based perovskite generates multiple vacancies for efficient water oxidation

Preparations and Photocatalytic Properties of Visible-Light-Active Zinc Ferrite-Doped TiO2 Photocatalyst

Synthesis and characterization of mixed oxides derived from lanthanum orthoferrite perovskite: exploring morphological, spectroscopic, and photocatalytic properties

Modification of the Electronic Structure and Surface State of LaFeO3 for Improved Visible Light Photoelectrochemical Water Oxidation

Enhanced Visible‐Light Photoactivities of Perovskite‐Type LaFeO3 Nanocrystals by Simultaneously Doping Er3+ and Coupling MgO for CO2 Reduction

Phase-controlled Synthesis, Surface Morphology, and Photocatalytic Activity of the Perovskite AlFeO3

Quasi-polymeric construction of stable perovskite-type LaFeO3/g-C3N4 heterostructured photocatalyst for improved Z-scheme photocatalytic activity via solid p-n heterojunction interfacial effect.

A Novel Delafossite Structured Visible-Light Sensitive AgFeO2 Photocatalyst: Preparation, Photocatalytic Properties, and Reaction Mechanism

High-performance visible-light active Sr-doped porous LaFeO3 semiconductor prepared via sol–gel method

Collating the structural, vibrational, and photocatalysis properties of LaFeO3 rare-earth orthoferrite nanoparticles synthesized by the sol-gel method

Solid-state synthesis of La0.75Gd0.25FeO3 nanoparticles for the enhanced photodegradation of methylene blue under sunlight irradiation

Facile Synthesis, Characterization, Catalytic and Photocatalytic Activity of Multiferroic BiFeO3 Perovskite Nanoparticles