Abstract:Photocatalytic hydrogen generation by solar energy is a promising approach to clean energy resource and has attracted great attention over the past decades. [1] Perovskites ABO3 structures provide the basic stable framework to both crystal and electronic structures modification, which have found extensive applications in photocatalysis, solar cells and photoelectrochemical (PEC) water splitting. [2] LaFeO3 has a suitable band gap of 2.07eV [3, 4] and exhibits excellent visible light photocatalytic performance. However, the poor charge transport and slow reaction kinetics at the surface [3, 4] are the main factors limiting its further improvement on photocatalytic application. To overcome these obstacles, transition metals (Mn, Co, Cu) are introduced into LaFeO3 and the photocurrent of 10% Cu doped sample is improved by three times than that of LaFeO3. The reduced charge transport resistance owing to the Fe3+ discharge is identified to benefit the PEC performance improvement after TM doping. On the other hand, the surface state of LaFeO3 is modified by electrodepositing of amorphous cobalt-phosphate (Co-Pi). It shows that the presence of Co-Pi down-shifts the onset potential by ~ 560 mV for anodic photocurrent and the improvement can be attributed to the enhanced water oxidation due to the CoII/CoIII-OH discharge on Co-Pi decorated layers. The transition anodic photocurrent is improved by about six times after Co-Pi coating under visible light at 0.50 V vs. Ag/AgCl and the electrochemical impedance spectroscopy certifies the enhanced charge transfer, which contributes to the meliorative anodic photocurrent. The incident photon-to-current conversion efficiencies of LaFeO3 can be promoted from 1.37% to 2.14% at 400 nm after Co-Pi coating. Our results demonstrate that modification of the electronic structure (TM doping) and surface state (Co-Pi coating) are the promising way to promote the photoconversion efficiency of LaFeO3-based PEC cells under visible light. References: X. Lu, S. Xie, H. Yang, Y. Tong, H. Ji, Chem. Soc. Rev., 43, 7581 (2014). Z. G. Yi and J. Ye, Appl. Phys. Lett., 91, 254108 (2007). K. M. Parida, K. H. Reddy, S. Martha, D. P. Das and N. Biswal, Int. J. Hydrogen Energy, 35, 12161 (2010). Q. Peng, B. Shan, Y. Wen and R. Chen, Int. J. Hydrogen Energy, 40, 15423 (2015).

High-performance visible-light active Sr-doped porous LaFeO3 semiconductor prepared via sol–gel method

Visible-Light-Driven Titania/Silica Photocatalyst Co-Doped with Boron and Ferrum

Visible-light-driven Boron/ferrum/cerium/titania Photocatalyst

Modification of the Electronic Structure and Surface State of LaFeO3 for Improved Visible Light Photoelectrochemical Water Oxidation

Fe-doped LaNi1-xFexO3 perovskite oxides for enhanced visible-light-driven photocatalytic activity

Novel Composite BiFeO3/ZrO2 and Its High Photocatalytic Performance under White LED Visible-Light Irradiation

Synthesis of new oxygen deficient triple layered perovskite oxides LaSr3Fe3-Cr O10-δ (x = 0.0, 0.2, and 0.5): Structural, optical, magnetic and photocatalytic properties

Perovskite LaFeO3-SrTiO3 Composite for Synergistically Enhanced NO Removal under Visible Light Excitation

Enhanced activation of peroxymonosulfate by Sr-doped LaFeO<sub>3</sub> perovskite for Orange I degradation in the water

Preparation of Lanthanum and Boron Co-Doped TiO2 by Modified Sol–gel Method and Study Their Photocatalytic Activity

Preparation of Lanthanum Ferritevia Ultrasound-assisted Sol-gel Method and Its Photocatalytic Activity

Ultrahigh Efficient Water Oxidation under Visible Light: Using Fe Dopants to Integrate Nanostructure and Cocatalyst in LaTiO2N System

Cobalt-doped LaFeO3 for photo-Fenton degradation of organic pollutants and visible-light-assisted water splitting

Synthesis and characterization of mixed oxides derived from lanthanum orthoferrite perovskite: exploring morphological, spectroscopic, and photocatalytic properties

Enhanced Charge Transport of LaFeO3 Via Transition Metal (mn, Co, Cu) Doping for Visible Light Photoelectrochemical Water Oxidation

Molten Salt Synthesized Submicron Perovskite La1–xSrxCoO3 Particles as Efficient Electrocatalyst for Water Electrolysis

(Y3+/Sm3+)-doped and co-doped CoFe2O4 for heterogeneous advanced oxidation process: structural, magneto-optical, and photocatalytic investigations

Tuning the ORR catalytic activity of LaFeO3-δ-based perovskite cathode for solid oxide fuel cells by doping with alkaline-earth metal elements

Effects of Mo doping on the structure, adsorption performance, and photocatalytic activity of LaFeO 3 nanoparticles: Experimental and DFT studies

Oxygen vacancies engineering of Fe doped LaCoO3 perovskite catalysts for efficient H2S selective oxidation

Enhanced activation of peroxymonosulfate by Sr-doped LaFeO3 perovskite for Orange I degradation in the water