Abstract:The steel, whose nominal yielding strength f(y) is greater than or equal to 460 MPa, is generally referred to as high strength steel (HSS). Through the comparison with conventional strength steel (CSS) members, HSS members are more vulnerable to local buckling since the component plates are usually designed to be more slender in order to exploit higher material strength. The different mechanical properties between HSS and CSS, including yielding strength, ductility and so on, may lead to different local buckling behavior of steel members. However, little guidance is applicable in existing standards for the stability design of HSS members. In this paper, elaborate finite element (FE) models of HSS welded I-section beams under the loading conditions of uniform moment (four-point loading) and moment gradient (three-point loading) were developed by means of the general-purpose FE software package and validated against the available test results. Continuous lateral supports were ideally applied to restrict the occurrence of coupling with overall lateral-torsional buckling. Comprehensive parametric analyses on key parameters containing the plate width-to-thickness ratio and the steel material properties were further conducted, reflecting the influence of these parameters on the mechanical performance of local stability. Through this work, the variation rules on rotation capacity and postbuckling resistance of HSS welded I-section beams with plate width-to-thickness ratio and steel nominal yielding strength were clarified. Taking into account the interaction of local buckling modes between flanges and webs, new cross-section classification of HSS welded I-section beams was proposed based on the FE analysis results. After the introduction of the concept of interactive local slenderness, the design methods of postbuckling ultimate moment resistance for HSS welded I-section beams subjected to uniform moment and moment gradient were also proposed, which were assessed by comparing the design results with the ones obtained from the corresponding design approaches in Eurocode 3, ANSI/AISC 360-16 and GB 50017-2017. And the reliability of the new proposals was also confirmed by further statistical analysis.

Interactive Buckling Failure Modes of Hybrid Steel Flexural Members

Buckling of Flexural-Shear Bracing System and Its Braced Steel Frames

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

Experimental Investigation into Flexural Buckling of Double-Limb Built-Up Plate Members under Compression

Flexural Strength of Hybrid Steel I-beams Based on Slenderness

Inelastic Storey-Buckling Factor of Steel Frames

Local buckling behavior of high strength steel welded I-section flexural members under uniform moment:

Investigation of Ductility in Hybrid and High Strength Steel Beams

Computational modelling of postbuckling behavior of composite T-stiffened panels with different bonding methods

Classification of I-section Flexural Members Based on Member Ductility

Postbuckling Resistance of High Strength Steel Welded I-section Beams Based on Interactive Slenderness

Flexural Tests and Behavior of Multi-Celled Corrugated-Plate CFST Members

Mechanism Analysis of Steel Frames Considering Moment–shear Interaction

Bending behavior test of hybrid high performance steel beam

Numerical simulation on seismic collapse of thin-walled steel moment frames considering post local buckling behavior

Experimental and Analytical Study on Local Buckling Behavior of High Strength Steel Welded I-Section Beams

Experimental and numerical investigation on flexural-torsional buckling of Q460 steel beams

Flexural-Torsional Buckling of Pultruded Fiber Reinforced Plastic Composite I-Beams: Experimental and Analytical Evaluations

Finite Element Analysis And Design Method Study On The Interactive Buckling Of Welded Steel Members Under Axial Compression

Local Delamination Buckling of Laminated Composite Beams Using Novel Joint Deformation Models

Flexural failure properties of fiber-reinforced hybrid laminated beam subject to three-point bending