Abstract:The steel, whose nominal yielding strength f(y) is greater than or equal to 460 MPa, is generally referred to as high strength steel (HSS). Through the comparison with conventional strength steel (CSS) members, HSS members are more vulnerable to local buckling since the component plates are usually designed to be more slender in order to exploit higher material strength. The different mechanical properties between HSS and CSS, including yielding strength, ductility and so on, may lead to different local buckling behavior of steel members. However, little guidance is applicable in existing standards for the stability design of HSS members. In this paper, elaborate finite element (FE) models of HSS welded I-section beams under the loading conditions of uniform moment (four-point loading) and moment gradient (three-point loading) were developed by means of the general-purpose FE software package and validated against the available test results. Continuous lateral supports were ideally applied to restrict the occurrence of coupling with overall lateral-torsional buckling. Comprehensive parametric analyses on key parameters containing the plate width-to-thickness ratio and the steel material properties were further conducted, reflecting the influence of these parameters on the mechanical performance of local stability. Through this work, the variation rules on rotation capacity and postbuckling resistance of HSS welded I-section beams with plate width-to-thickness ratio and steel nominal yielding strength were clarified. Taking into account the interaction of local buckling modes between flanges and webs, new cross-section classification of HSS welded I-section beams was proposed based on the FE analysis results. After the introduction of the concept of interactive local slenderness, the design methods of postbuckling ultimate moment resistance for HSS welded I-section beams subjected to uniform moment and moment gradient were also proposed, which were assessed by comparing the design results with the ones obtained from the corresponding design approaches in Eurocode 3, ANSI/AISC 360-16 and GB 50017-2017. And the reliability of the new proposals was also confirmed by further statistical analysis.

Flexural Strength of Hybrid Steel I-beams Based on Slenderness

Investigation of Ductility in Hybrid and High Strength Steel Beams

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

Interactive Buckling Failure Modes of Hybrid Steel Flexural Members

RESEARCH ON FLEXURAL PERFORMANCE OF DOUBLE-STEEL REINFORCED CONCRETE BEAM

Flexural Strength Design of Hybrid FRP-Steel Reinforced Concrete Beams

Local buckling behavior of high strength steel welded I-section flexural members under uniform moment:

Experimental and numerical investigation on flexural-torsional buckling of Q460 steel beams

Postbuckling Resistance of High Strength Steel Welded I-section Beams Based on Interactive Slenderness

Bending behavior test of hybrid high performance steel beam

Flexural behavior of cold-formed steel I-beams strengthened in the web with different materials

Flexural Strength and Rotation Capacity of Welded I-section Steel Beams with Longitudinally Profiled Flanges

Flexural Performance of Rectangular Cfst Members

Finite element analysis of ductility and flexural capacity of FRP and steel bars hybrid reinforced concrete beams

Flexural Behavior of Novel Hybrid Multicell GFRP-concrete Beam

Post-yielding deflection calculation of flexural hybrid reinforced concrete with a combination of fiber reinforced polymer and steel bars

Flexural design of cold-formed steel built-up sections failing by local buckling: Development of generalised direct strength method

Classification of I-section Flexural Members Based on Member Ductility

Experimental and Analytical Study on Local Buckling Behavior of High Strength Steel Welded I-Section Beams

Strength of Multi-Span Composite Beams Subjected to Combined Flexure and Torsion

Flexural property and design method evaluation of BFRP and steel bars hybrid reinforced concrete beams