Abstract:The dc-dc topologies with capacitive output filter are going to be widely used especially for high-output current applications because of its inherent advantages in the lower voltage stress on rectifiers and the smaller occupied printed circuit board layout area at the secondary side. However, the parasitic resonance between the equivalent leakage inductance of the power transformer and the equivalent output junction capacitance of the rectifier still practically exists in the center-tapped rectification configuration, which leads to considerable voltage ringing on the rectifier and then results in the utilization of the rectifier with much higher breakdown voltage rate and the decrease of conversion efficiency. Moreover, the relatively larger output-current ripple induces the both larger conduction loss in the secondary-side windings of the power transformer and the capacitive output filter. In this paper, a novel symmetrical rectifier configuration is proposed, which can effectively clamp the practical voltage stress on the rectifier without any parasitical voltage spike and reduce the output-current ripple due to the bypass effect of the auxiliary flying-balancing capacitors. The leakage inductance and the output filter capacitor can be treated as an inherent small LC filter to reduce the output voltage ripple further. Based on the theoretical analysis and the optimal design considerations, a 300-W lab-made LLC resonant dc-dc converter with this proposed configuration is built up to verify its advantages in high conversion efficiency.

A Novel Balanced Winding Topology to Mitigate Emi Without the Need for A Y-Capacitor

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

Design of Transformer Shielding Foil Structure for Minimizing Common-Mode Noise in LLC Resonant Converters

A Systematic Design and Optimization Technique for the Suppression of EMI Common Mode (CM) Noise

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

Design of the Number of Transformer Shielding Winding Turns for Minimizing Low-Frequency Common-Mode Noise in Flyback Converters

Capacitor Voltage Balancing for Multi-Level Dual-Active-Bridge DC-DC Converters

The Passive Emi Cancellation Effects Of Y Capacitor And Cm Model Of Transformers Used In Switching Mode Power Supplies (Smps)

Suppressing Method of Common-Mode Noise in MHz 380V-12V DCX Converter

External Magnetic Field Minimization for the Integrated Magnetics in Series Resonant Converter

Suppressing Methods of Common-Mode Noise in LLC Resonant DC-DC Converters

Capacitor Voltage Balancing Control for a Novel 5-Level Dual Active Bridge Converter

Design Guidelines for Y Capacitance Based on CM Noise Caused by Line Frequency Switch of Totem-Pole PFC

Active Power Decoupling for a Modified Modular Multilevel Converter to Decrease Submodule Capacitor Voltage Ripples and Power Losses

A Novel Symmetrical Rectifier Configuration with Low Voltage Stress and Ultralow Output-Current Ripple

Evaluation Method of Flyback Converter Behaviors on Common-Mode Noise

RLC Balance Technique of Transformer to Reduce CM EMI for Isolated DC-DC Converters

Complementary Couple-Turns: An Effective Method for Reducing Common-Mode Noise in Full-Bridge LLC Resonant Converter With Split Primary Winding Transformer

Capacitor Voltage Balancing Algorithm with Redundant Level Modulation for a Five Level Converter with Reduced Device Count

A novel current-feed soft-switching two-switch forward resonant DC-DC Transformer (DCX)

Novel boost PFC with low common mode EMI: modeling and design