Abstract:A simple and highly selective flow injection on-line pre-concentration and separation-flame atomic absorption spectrometric method was developed for routine analysis of trace amounts of lead in biological and environmental samples. The selective preconcentration of lead was achieved in a wide range of sample acidity (0.075 to > or = 3 mol L(-1)HNO3) on a microcolumn (145 microL) packed with a macrocycle immobilized on silica gel. The lead retained on the column was effectively eluted with an EDTA solution (0.03 mol L(-1), pH 10.5). Three kinds of potential interferences, i.e., preconcentration inferences from metal ions with an ionic radius similar to that of Pb(II) due to their competition for the cavity of the macrocyle, elution kinetic interferences from ions which form stable complexes with EDTA due to their competition for EDTA, and interferences in the atomizer from residual matrix, were evaluated and compared in view of the read-out mode of the analyte response (peak area vs peak height), column wash step (with vs without), column capacity (50 vs 145 microL), and column shape (conical vs cylindrical). The results showed that a combination of increase in column capacity, quantitation based on peak area, and use of dilute nitric acid for column wash before elution efficiently avoid the above-mentioned potential interferences. With the use of a 145 microL column the present system tolerated up to 0.1 g L(-1) Ba(II), 1 g L(-1) Sr(II), and at least 10 g L(-1) Fe(III), Cu(II), Ni(II), Zn(II), Cd(II), Al(III), K(I), Na(I), CaII), and Mg(II) in the sample digest. Further improvement of the interference tolerance can be achieved by increasing column capacity if more complicated samples need to be analyzed. At a sample loading rate of 3.9 mL min(-1) with 30-s preconcentration, an enrichment factor of 52, a detection limit (3s) of 5 micrograms L(-1) Pb in the digest and a sampling frequency of 63 h(-1) were obtained. The precision (RSD, n = 11) at the 200 micrograms L(-1) level was 1.9%. The enrichment factor and the detection limit can be further improved by increasing sample loading rate without degradation in the efficiency due to the favorable kinetics and low hydrodynamic impedance of the present system. The analytical results obtained by the proposed method for a number of biological and environmental standard reference materials were in good agreement with the certified and recommended values.

Determination of Trace Pb by Flow Injection On-Line Co-Precipitation Hydride Generation Atomic Fluorescence Spectrometry

A Simple and Sensitive Flow-Injection On-line Preconcentration Coupled with Hydride Generation Atomic Fluorescence Spectrometry for the Determination of Ultra-trace Lead in Water, Wine, and Rice

Determination of trace lead by hydride generation–inductively coupled plasma–mass spectrometry

Determination of trace amounts of germanium by flow injection hydride generation atomic fluorescence spectrometry with on-line coprecipitation

Determination of Trace Amounts of Lead in Biological-Materials by Flow-Injection Hydride-Generation-Aas with Sensitivity Enhancements Using Nitroso-R-Salt

Determination of trace cobalt, nickel and cadmium by on-line flow injection analysis with coprecipitation preconcentration FAAS

Simultaneous Measurements of Cr, Cd, Hg and Pb Species in Ng L-1 Levels by Interfacing High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry.

An Efficient Flow-Injection System with On-Line Ion-Exchange Preconcentration for the Determination of Trace Amounts of Heavy Metals by Atomic Absorption Spectrometry

Online Flow-Injection Cobalt-Ammonium Pyrrolidin-1-Yldithioformate Coprecipitation for Preconcentration of Trace Amounts of Metals in Waters with Simultaneous Determination by Inductively-Coupled Plasma-Atomic Emission-Spectrometry

Determination of Pb and Cd in water sample by on-line ion-exchange preconcentration-FAAS

Determination of lead in complex sample matrices by atomic fluorescence spectrometry: optimisation of online hydride generation

Simultaneous on-line preconcentration and determination of trace metals in environmental samples using a modified nanometer-sized alumina packed micro-column by flow injection combined with ICP-OES

Application of a macrocycle immobilized silica gel sorbent to flow injection on-line microcolumn preconcentration and separation coupled with flame atomic absorption spectrometry for interference-free determination of trace lead in biological and environmental samples

Determination of Trace and Ultra-Trace Amounts of Germanium in Environmental Samples by Preconcentration in a Graphite Furnace Using a Flow Injection Hydride Generation Technique

On-line separation and preconcentration of trace cadmium in environmental water samples by micro column filled with modified nanometer Si-HAP prior to FAAS determination

Determination of Ni, Cu and Hg by flow injection preconcentration coupled with HPLC

A robust method for the determination of lead in water samples using flow injection hydride generation atomic absorption spectrometry

Rapid Determination of Hg Isotopes in Low Concentration Water Samples by Flow Injection-Plasma Electrochemical Vapor Generation

Determination of Trace Mercury in Water Samples by Cloud Point Extraction Coupled with Atomic Fluorescence Spectrometry

THE DETERMINATION OF TRACE AMOUNTS OF HEAVY-METALS IN WATERS BY A FLOW-INJECTION SYSTEM INCLUDING ION-EXCHANGE PRECONCENTRATION AND FLAME ATOMIC-ABSORPTION SPECTROMETRIC DETECTION

The Determination of Trace Amounts of Tin by Flow-Injection Hydride Generation Atomic-Absorption Spectrometry with On-Line Ion-Exchange Separation and Preconcentration.