Abstract:Journal of Vibration and Control, Ahead of Print. Wind turbine design and operation will benefit from a better understanding of blade dynamics. Usually, only one surface or one side of a 3D structure is measured in Scanning Laser Doppler Vibrometer (SLDV) tests due to test setup and instrumentation limitations. However, in this work, we demonstrate an approach to overcome these limitations while also using an SLDV that provides high spatial resolution measurement. In the case of a wind turbine blade, only one surface is typically measured; however, it is beneficial to investigate both blade global modes and the relative motions of the two blade surfaces by using both numerical models and experimental tests. This work creatively develops both experimental and numerical approaches to investigate the dynamics and the relative motions of both surfaces of the wind turbine blade from global and local perspectives. On the experimental side, experimental modal testing is conducted on both surfaces of the wind turbine blade with a high spatial resolution 3D SLDV. The two surfaces of the wind turbine blade are measured and stitched together to build the blade experimental mode shapes of both surfaces. A total of over 1500 points are scanned from both surfaces of the blade in a non-contact fashion to obtain not only the global bending modes (flap-wise and edge-wise), the global torsional modes, but also the localized panel mode shapes. On the numerical side, a finite element model of the blade is developed to obtain the numerical mode shapes. The experimental mode shapes on either one surface or both surfaces of the blade are used to validate the blade finite element model. The mode shape correspondence between the model and the test is also identified. With the availability of both experimental and numerical mode shapes, localized panel modes of the wind turbine blade are observed and characterized, and as a result the numerical model is validated. This work provides useful case studies for the design and structural analysis of wind turbine blades based on both the experimental observations and the validation of numerical models typical of those used for blade design and blade structural analysis.

Modal Measurement and Analysis of Twisted Blade in Low-pressure Stage of 300MW Turbine

Analysis of Vibration Monitoring Data of an Onshore Wind Turbine under Different Operational Conditions

Study on Discrete Modeling Method of Modal Testing for Turbine Blade

Topological Structure Optimization of Finite Element based on Modal Analysis about Steam Turbine Blade

Research on Boundary Conditions of T Steam Turbine Blade by Finite Element Model Analysis

Statistical Investigations of Profile Error Impact on Flow and Performance of a Low-Pressure Turbine Cascade

Structure and Modal Analysis of the Last Stage Blade in Steam Turbine under Low Volume Flow Conditions

Pressure pulsation in small opening operating mode of pump turbine’s turbine mode

Research on Vibration Characteristics of Last Stage Blade Based on Blade Tip-Timing Technology

Modal analysis for a 1:10 model of turbine-dynamotor frame foundation

Numerical Analysis on the Influence of the Twisted Blade on the Aerodynamic Performance of Turbine

Modal analysis of turbine based on fluid-thermo-structure coupling

Modal Analysis of Francis Turbine Blade Based on Fluid-Structure Interaction Theorem

Modal Analysis of the 1200 MW Turbo-generator Stator End Windings

Modal Verification and Strength Analysis of Bladed Rotors of Turbine in Rated Working Conditions

Bending moment characteristic analysis of utility-scale onshore wind turbine blades based on monitoring data

Experimental and numerical investigation of the structural dynamic characteristics for both surfaces of a wind turbine blade

Nonlinear Flap-Wise Vibration Characteristics of Wind Turbine Blades Based on Multi-Scale Analysis Method

Modal test and finite element analysis of a turbine disk

Influence of rotation on the modal characteristics of a bulb turbine unit rotor

Improving a Composite Wind Turbine Blade Considering Minimizing the Prospect of Flutter with the Method of Modal Analysis Technique