Abstract:A digital speckle based stereo microscope strain measurement system is developed to investigate the forming limit diagram (FLD) of miniature sheet metal under hydraulic bulge testing conditions. A stochastic speckle pattern is sprayed on the surface of the tested metal before forming. A series of images are recorded by two cameras mounted on a binocular stereo microscope during the hydroforming process. The critical major and minor strains are then calculated and plotted to construct the forming limit curve. The key technologies applied in the system are discussed in detail, including stereo microscope calibration and large deformation strain filed determination. First, considering complex optical paths and high magnification of the stereo microscope, an accurate combined distortion correction model is proposed to optimize the intrinsic and extrinsic parameters of the stereo microscope. Then, to solve the problem of strain measurement of the tested metal in large deformation situation, a large deformation measurement scheme based on deformation continuity of adjacent images is proposed. And an algorithm of limit strain determination based on spline model is proposed to calculate the critical strains at the onset of plastic instability. Finally, with our self-developed stereo microscope imaging system and sheet metal hydraulic bulging setup, FLD determination tests are conducted to validate the performance of the system. And the measured FLD is compared with the simulation results that predicted by the finite element method. The simulation and experimental results confirm that the proposed system is feasible to measure the full-field strain during the whole bulging processes and provides a better solution for forming limit diagram prediction.

Deformation test system design of a new type of bimetallic strip

A Novel Method To Enhance The Sensitivity For Two-Degrees-Of-Freedom Straightness Measurement

Development of Laser-Based Displacement Monitoring System and Its Application to Large-Scale Spatial Structures

Measurement of deformed surface and key data processing based on reverse engineering

Measuring system development for dynamic welding distortion and thermal cycle

A NEW MEASURING SYSTEM FOR WELDING DYNAMIC DISTORTION AND THERMAL CYCLE

3D Digital Speckle Analysis System for Dynamic Strain Measurement in Sheet Deformation

Measurement of deformations for copper/aluminum clad under tension with digital speckle correlation

Digital speckle based strain measurement system for forming limit diagram prediction

Multi-channel non-destructive testing of steel strip stress based on magneto-elastic effect

MEASUREMENT SYSTEM AND APPLICATION OF THE DEFORMATION BASED ON LabVIEW

Digital Speckle Based Stereo Microscope Strain Measurement System for Sheet Metal Forming by Hydraulic Bulge Tests

Development of Welding Thermal Cycle and Dynamic Deformation Measurement System and Its Application

Design of Thin Film Magnetostrictive Coefficient Computer Assistant Measuring System

Development of Noncontact Measurement System for Mechanic Testing of Car Body Materials

Defect and Tension Detection of Magnetostrictive Longitudinal Guided Wave for Steel Strip

Design and Test of a New Type Amplifier-based Sensing Device for High Temperature Deformation Monitoring

Design and Implementation of High Precision Online Thickness Gauge by Laser Displacement Sensor

Research on a Super-Sub-Arc Bivariate Relative Angle Thermal Deformation Testing Method without Pitch Angle Limitation

Non-contact surface thermal deformation measurement based on chromatic confocal sensor

A Defects Detection Method Based on Infrared Scanning in Laser Metal Deposition Process