Abstract:A finite element computational methodology is presented for predicting the temperature distribution, fluid flow, and thermal stresses evolving in a solidifying ingot, which itself is growing in length, during the start-up phase of a continuous casting process, with a particular reference to aluminum casting. The approach is based on the coupling of a thermal and flow model with a stress model, The thermal flow model is developed using a deforming finite element method with an Eulerian-Lagrangian transformation to account for the fact that the ingot itself is also growing at a prescribed casting speed. The stress model is developed also by the finite element method, with mechanical deformations in the solidifying materials described by a hypoelastic-viscoplastic constitutive relation. The integrated model has been applied to study the dynamic development of temperature, flow, and stresses in the solidifying ingot during the start-up phase for continuous casting of aluminum. The results show that the fluid flow and temperature distribution experience a rapid change at the initial stage but that the change slows down later in the process as it approaches to the steady state. Computed results compare reasonably well with experimental measurements for temperature distributions in the ingot. It is found that the thermal stresses in general evolve from small to big in magnitude and from compressive to tensile in the solidifying ingot. The hoop stress is larger than other stress components, in particular in the outer surface region. The air gap formed between the ingot and the bottom block increases initially and decreases afterward as a result of stress relaxation.

Modeling Coupled Fluid Flow and Heat Transfer During the Low Pressure Casting Process of Thin-Walled Plate Castings

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

Study and Application of Mold Filling Simulation of Shaped Castings

Numerical simulation and experimental verification of the initial temperature distribution of castings during mold filling process

Research Development of Thermal-Mechanical Numerical Modeling of Casting Stress Field

Numerical simulation of mould filling and heat transfer of anti-gravity thin-walled casting

An Improved Mathematical Model to Simulate Mold Filling Process in High Pressure Die Casting Using CLSVOF Method and CSF Model

A coupled model on fluid flow, heat transfer and solidification in continuous casting mold

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

Study on Numerical Simulation of Mold Filling and Solidification Processes under Pressure Conditions

Numerical Simulation of Fluid Flow and Solidification in Continuous Slab Casting Mould Based on Inverse Heat Transfer Calculation

Study on numerical simulation of mold-filling and solidification processes of shaped casting

Numerical Simulation of 3-D Free Surface of Mould Filling Process

INTEGRATED FINITE ELEMENT MODEL FOR TRANSIENT FLUID FLOW AND THERMAL STRESSES DURING CONTINUOUS CASTING

A Thermomechanical Finite Element Model for Simulating the Solidification Process of Squeeze Casting

3D Numerical Simulation of Temperature Field Coupled with Flow Field of the Liquid Metal in Shot Sleeve of Die Casting Process

Application of Modeling and Simulation of Thermal Stress in Solidification Process of a Heavy Steel Casting

Investigation of Solidification, Heat Transfer and Fluid Flow in Continuous Casting of Steel Using an Advanced Modeling Approach

Modeling and Simulation of the Fluid Flow in Continuous Slab Casting Mould

Mathematical Model of Fluid Flow and Solidification in Mold Region of Continuous Slab Casting

Study on the Critical Mould Entry Velocities of Thin-wall Castings by Numerical Simulation