Abstract:The temperature dependence of coercivity of nanocrystalline Nd4Fe77Co3B16 is analyzed in this article. The best linear fit of HC(T)/Ms(T) vs 2K1(T)/μ0Ms2(T) indicates that HC is controlled by a nucleation process in the nanocrystalline two-phase magnet. The effects of additives (Hf, Ga) and magnetic field heat treatment on the microstructure and magnetic interaction are also studied. It is found that the condition of the grain shapes is improved after adding Hf and Ga, but the surfaces are deteriorated by some precipitates present on the boundary. Taking into account the values of α, Neff, the results of transmission electron microscopy (TEM) and Mossbauer spectroscopy, the magnetic field heat treatment not only induces grain refinement but also causes a uniform distribution of the soft and hard phases, and therefore it is a recommendable method for improving the condition of microstructure. From the analysis of high resolution TEM, amorphous phase with scale of <10 Å exists between the different phase’s grains due to the mismatch of their lattices. The existence of amorphous phase reduces the exchange-coupled interaction between the two magnetic phases and results in a relatively low coercivity in the nanocrystalline magnet. The magnetic interaction in Nd2Fe14B/Fe3B+αFe based nanocrystalline magnet was studied using δM plots. The results show that the exchange-coupled interaction is greatly enhanced in the sample annealed with magnetic heat treatment, achieving the highest energy product (BH)max=15.8 MGOe.

Study on Temperature Characteristics of Hysteresis Properties of Fe-Co Alloy

Research on the Magnetic Properties of High-Saturation Magnetically Induced Alloy Motors under Magnetocaloric Coupling

The hysteresis properties analysis of Fe-4 wt% Si prepared by high purity metallurgy

HYSTERESIS BEHAVIOR AND MICROSTRUCTURE OF NANOCOMPOSITE PERMANENT MAGNETIC ALLOYS

Temperature stability of coercivity in mischmetal-Fe-Co-B melt-spun ribbons

Compositional Design and Microstructural Tuning of Fe–Si–Co Soft Magnetic Alloys with Enhanced Performance

Magnetic Properties of Hard Magnetic Alloy Fe – 28% Cr – 13.4% Co – 2% Mo – 0.5% Si

Significant Reorientation Transition of Magnetic Damping Anisotropy in Co2FeAl Heusler Alloy Films at Low Temperatures.

Experimentally correlating thermal hysteresis and phase compatibility in multifunctional Heusler alloys

Effect of Si/Al addition on magnetic properties of Fe-Co alloy

Influence of Isothermal Heating on the Curie Temperature of FeCoB Bulk Amorphous Alloy

Preparation of FeCo-based amorphous alloys with excellent soft magnetism and high glass transition temperature

Study on Thermomagnetic Treatment Fe-25.5Cr-12Co Permanent Magnetic Alloy

CoFeAlB alloy with low damping and low magnetization for spin transfer torque switching

Properties and analysis of coercivity mechanism of NdFeB nanocrystalline magnetic alloys

Differences of the Magnetic Hysteresis Behaviors in the Magnetostructural Transformation Mn1−xVxCoGe Alloys

Analysis of the coercivity of amorphous ferromagnetic alloys

Improvement of Magnetic Properties of 34Ni-29Co-3mo-fe Alloy by Adjusting the Composition and Controlling the Textures of Recrystallization

Controllable Magnetization Precession Dynamics and Damping Anisotropy in Co2FeAl Heusler-alloy Films

THE NUCLEATION PROCESS AND MAGNETIC INTERACTION IN NANOCRYSTALLINE ALLOY ND4FE77CO3B16

Magnetization Precession and Damping in Co2FeSi Heusler Alloy Thin Films