A Morphological Study of Lumbar Transverse Process

LI Bing,JIANG Baoguo,FU Zhongguo,ZHANG Dianying,DU Xianghe,WANG Tianbing
DOI: https://doi.org/10.3969/j.issn.2095-252x.2003.02.008
2003-01-01
Abstract:Objective A morphological study that focused on transverse process (TP) of lumbar vertebrae was conducted, which would provide detail anatomic data for posterior operations in lumbar spine, especially in posterolateral gutter fusion. Methods A total of 100 vertebrae from L-5 of 20 Chinese people were scanned by a GE LightSpeed QX/ i computerized tomographic scanner in the axial plane. After images reconstruction using Volume Analysis 2 - D reformatting software, the parameters of 200 lumbar transverse processes, including width, length, thickness of TP and the angles of inclincation of TP in coronal and horizontal section were measured by the same software. The morphologic structure and segmental difference of TP were also observed. Results There was no significant difference between left and right side of every parameter; Excluding L5 , there was no significant difference between medial and middle width of TP in the same segment (P 0.05) , but obvious significant difference between medial and lateral one (P 0.01) ; There was significant difference among the medial, middle and lateral length of TP in the same segment ( P 0.01) . The length of L[ was the shortest, and was about 10mm.The lengths of L2,4,5 were similar, and were about 15mm. The length of L3 was the longest, and was about 19mm; There was no obvious change from L1-4 in thickness, but the thickness of L5 was double that of L4 . The width and thickness of all segments from medial to lateral gradually changed to narrow and thin. L5 was the greatest in width and thickness among all segments. Axial Inclination projected posteriorly without exception . All coronal inclination almost projected horizontally. Conclusions TP is an important part of posterior lumbar vertebrae. There are some orderlinesses in TP morphologic study, but some parameters express obvious individualy. TP parameters obtained from reformatted GT images preoperatively could ensure utmost safety posterolateral gutter fusion procedures and improve fusion rate.
What problem does this paper attempt to address?