Abstract:The series resonance type fault current limiter has the advantages of simple operating principle and topological structure,etc. The primary parameter of series resonance type fault current limiter for high-voltage system is reasonable.However,in the process of restraining fault current after a fault occurrence in electrical network,the capacitor and parallel inverter switch will confront poor working condition.This paper studies the above condition by simulation using the software Matlab.Proceeding from the study,we arrive at the conclusions:1)in the process of closing the inverter switch short circuit capacitor to make the current limiter work in short circuit current limiting mode switching from normal operation mode,there is higher-order of voltage(current)oscillation between capacitor and parallel inverter switch,and the peak value of voltage(current)increases and oscillates with the growing of the speed for closing the inverter switch; 2)when the inverter switch is composed of semiconductor device,control system must respond to short circuit and close the inverter switch quickly,otherwise,the semiconductor device may be damaged by over current(voltage);3)during fault current limiter working in current limiting mode to short circuit loop being shut off by relay protection device,the inverter switch will bear the full fault current and oscillation current.If using semiconductor device as inverter switch,the capacity of semiconductor device must be chosen according to the working condition.

Approaching to the Impact of Capacitance of ZnO Varistor on Its Failure Mechanism under Impulse Stress

Harmonic Characteristics Of Leakage Currents Of Zno Varistors Under Impulse Aging

Brief Analysis on Pore Emergence and Prevention of ZnO Varistor

Research progress of degradation mechanism of ZnO varistors

Effect of Interfacial Charge Relaxation on Conducting Behavior of Zno Varistors under Time Varying Electric Fields

Influence of Grain Size on Distribution of Temperature and Thermal Stress in ZnO Varistor Ceramics

INFLUENCES OF THE MICROSTRUCTURE ON CURRENT DISTRIBUTION IN ZnO VARISTORS

Scattered Phenomenon of Energy Absorption Capabilities of ZnO Varistors

The Degradation of Silicone Rubber Composites with ZnO Microvaristors under Impulse Voltage

Statistical Pulse Degradation Characteristics of Grain Boundaries in a ZnO Varistor Based on Microcontact Measurement

The Electrical Model and Harmonic Characteristics of ZnO Varistor Considering Unipoilar Impulse Aging Polarity Effect

Transient conduction of ZnO varistors under moderate time-varying voltages: Dynamics of interfacial charges of the double Schottky barrier

Investigation on the Response of ZnO/SiR Composites under Impulse Voltage

Microstructure Simulation on Puncturing Phenomenon of ZnO Varistor under High Current

Influence Factors of Residual Voltage Ratio of ZnO Variostor

Statistic Analysis on Nonuniformity of Electrical Parameters of ZnO Varistors

The Correlation Mechanism that Micro-Structure Parameters of ZnO Varistor to the Macroscopic Electrical Characteristics

Simulation on surge responses of ZnO varistors by Voronoi network with actual grain boundary model

Electrical Parameter Statistic Analysis and Parallel Coordination of ZnO Varistors in Low-Voltage Protection Devices

Voltage Fluctuation in A Supercapacitor During A High-G Impact

Simulation Study of Series Resonance Type Fault Current Limiter