Abstract:The device was developed to accurately measure the Concentration of pulverized coal in the pneumatic conveying pipe. The sensor assembly was composed of γ-ray source, tube of the sensor, ionization chamber fill with inert gas electrometer and lead cannon tube shield. The γ point source was fixed at the cross-section centre of the pipe, the collimation exit portal was vertical to the axis line of the conduct, in which the outgoing beam of the γ rays was assumed at the plane 360 degrees; the profile of the ionization chamber was designed ring cross section, independent mult-cavity. The γ-ray from the source penetrated the gas-solid two phase flow and the single tube wall, arrived at the corresponding independent cavity. The inert gas filled in the cavity was ionized by the γ-ray, the ions was collected by the high voltage plates, the ionic stream was converted into direct voltage by the electrometer in the cavity, as the output of the cavity. The concentration of the corresponding sector in the tube could be determined according to the law of γ-ray mutual effect with the matter. The arithmetic mean of the output voltages from the electrometers in the cavities of the ionization chamber was taken as the measured value of volume concentration of the pulverized coal in the tube. The proving trial shows that the input-output character of the sensor assembly was the phase distribution; the measuring accuracy was superior 2%, the γ-ray radioactivity requirement was reduced obviously as only single tube wall was required to be penetrated by γ-ray.

STUDY ON TECHNOLOGY OF MEASURING PULVERIZED COAL CONCENTRATION BY USING MOMENTUM METHOD IN DUST-COAL TRANSPORTING PIPELINE FOR UTILITY BOILERS

Studies of Pulverized Coal Concentration Measurement in 660MW Boiler Coal Pipe

Research on a Thermal Probe Method for the Measurement of Pulverized-coal Concentration in a Pulverized-coal Transport System of a Power Plant

Experimental Study on On-Line Monitoring Pulverized Coal Fineness of 300 MW Coal-Fired Plant by Digital Holography

RESEARCHES ON THE IGNITION REGULATION OF THE PULVERIZED COAL-AIR FLOW IN A TUBE

Multi-Scale Analysis of Acoustic Emission Signals in Dense-Phase Pneumatic Conveying of Pulverized Coal at High Pressure

Concentration Measurement with Thermal Probe for Pulverized Coal in the Pneumatic Pipeline of Power Plant

On-line Electromagnetic Wave Based Coal Concentration Monitoring Technique for Pipe Flow

Design and Experimental Study on the Pulverized Coal Concentration Sensor Based on Gamma-Ray Absorption Method

STUDY ON KEY TECHNOLOGIES AFFECTING THE CONVEYING AND COMBUSTION PROPERTIES OF HIGH DENSITY PULVERIZED COAL

Measurement of the Mass Flow and Velocity Distributions of Pulverized Fuel in Primary Air Pipes Using Electrostatic Sensing Techniques

Investigations into the Ignition Behaviors of Pulverized Coals and Coal Blends in a Drop Tube Furnace Using Flame Monitoring Techniques

Measurement on the Pulverized Coal Concentration after a Combination of Two Elbows Using Method of Optic Fluctuation Theory

Design and Implementation of A Pulverised Coal Flow Monitoring System for Coal-Fired Power Plant Applications

Quantitative Characterization of Pulverized Coal and Biomass–coal Blends in Pneumatic Conveying Pipelines Using Electrostatic Sensor Arrays and Data Fusion Techniques

Pulverized coal flow metering on a full-scale power plant using electrostatic sensor arrays

THE STUDY OF DIAGNOSING THE RUNNING CONDITION OF PULVERIZED COAL IN PIPE

Fundamental Research on the Size and Velocity Measurements of Coal Powder by Trajectory Imaging

Experimental Investigation of Pipeline Pulverized Coal Flow Measurements Using a Venturi Tube

A New Estimation Method for the Powder Amount of A Coal Pulverizer with Double Inputs and Double Outputs

TECHNIQUE FOR MEASURING CONCENTRATION OF GAS - SOLID TWO - PHASE FLOW INSIDE THE PIPE BASED ON ULTRASONIC METHOD