Abstract:The supplementary steam structure is used in the high pressure cylinder to increase the power output of steam turbine through increase the mass flow rate. In this work, the supplementary steam structure installed between the fifth and sixth stage of the high pressure cylinder of steam turbine is taken as the research object. The flow field and aerodynamic performance of the fifth and sixth stage was numerically investigated at different supplement steam rates using the three-dimensional Reynolds-Averaged Navier-Stokes (RANS) and k–ε turbulent model solutions. The inlet/outlet boundary flow conditions of the stator labyrinth seal of the sixth stage was determined based on the steady computations at three different supplementary steam rates. The unsteady flow field and rotordynamic coefficients of the stator labyrinth seal were calculated using the multi-frequency elliptical whirling orbit model and dynamic grid technique based on the unsteady RANS solutions. The numerical results show that the supplementary steam jet impacts on the hub regions of the stator blade of the sixth stage and results in the vortex flow. This flow behavior leads to the non-uniform inlet aerodynamic parameters at the entrance of the stator blade of the sixth stage. The aerodynamic performance decreases with the increase of the supplementary steam rates. The supplementary steam jet changes the inlet preswirl and boundary flow condition of the stator labyrinth seal of the sixth stage. The fluid excitation rotordynamic coefficients of the stator labyrinth seal would change due to the variation of the boundary flow condition. The detailed flow pattern of the turbine stage and variation of the rotordynamic coefficients of the stator labyrinth seal at different supplementary steam rates were also illustrated and discussed.

Improvements of Stators in 200MW Steam Turbine Mid-Pressure Cylinder

NUMERICAL INVESTIGATION OF STATOR CLOCKING EFFECTS ON THE DOWNSTREAM STATOR IN A 1.5-STAGE AXIAL TURBINE

Research on Optimization of Intermediate Pressure Cylinder Start Process for 600MW Unit

Application of new techniques to renovation of 200 MW steam turbine

Comparative Experimental Investigation On Aerodynamic Performance Of A Steam Turbine Cascades, Part Ii - Stator Vanes

Study on the Turbine Stator Secondary Flow Using Moving Cylinders to Simulate Rotating Blades

Effects of Stator Bending on Pressure Field and Loss of Transonic Turbine Stage

Effect of Oblique Stator on the Aerodynamic Performance and Erosion Characteristics of Governing Stage Blades in a Supercritical Steam Turbine

Bowed Stators: An Example of CFD Applied to Improve Multistage Compressor Efficiency

Experimental Study on Aerodynamic Characteristics of Blade Profile in a Compressor Stator

Optimisation of a Low-Pressure Multistage Steam Turbine Towards Decreasing the Wetness Losses and Aerodynamic Losses

Analysis of Flow Structures in a High Pressure Turbine Stator Based on Optimized Endwalls

Low-speed Experimental Verification on High-loading Turbine Blade Design Idea

Numerical Investigations on the Aerodynamic Performance of Turbine Stage and Rotordynamic Characteristics of Stator Seal with Consideration of Supplementary Steam

Conjugate Heat Transfer 3-D Optimization for Turbine Stator

Numerical Investigation of Stator Blades Bow Effect on the Rotor Blade Erosion of a Wet Steam Turbine

Optimization of cantilevered stators in an industrial multistage compressor to improve efficiency

Numerical Investigation of a Turbine Stator with Nonaxisymmetric Endwall Profiling

Effect of Blade Bowing and Local Modification on High-Turning Angle Compressor Stator Performance

ICOPE-15-C053 New Technologies Approach to Design Impulse High Pressure Turbine Stages

Flow Field Improvement by Bowed Stator Stages in a Compressor with Different Axial Gaps under Near Stall Condition