Abstract:At present, the most prominent technical problems of small and medium capacity expanders are low internal efficiency and small expansion ratio. In order to promote the practical application of small and medium capacity Organic Rankine Cycle (ORC) system, improving the thermodynamic performance of the expander was a remarkable issue, and the systematic research on the irreversibility of expander's working process is the fundamental work to achieve this goal. Summarizing the related research on various small capacity volumetric expanders, the research on flow problem is lacked. For an atypical volumetric expander, the flow mechanism of single screw expanders (SSEs) is more complex. In this paper, we discussed the effect of the pressure loss in the inlet and exhaust passages on the performance of SSEs. We selected two SSE prototypes developed by our laboratory to carry out the experiment under variable working conditions. The internal volume ratios are 2.95 and 3.98 respectively. The pressure differences of inlet and exhaust passages were measured. In order to evaluate the effect of the flow losses on the performance, we defined two indexes: pressure loss rate (PLR) and pressure energy loss influence rate of shaft efficiency (PELRe). From the results, the pressure losses of inlet and exhaust passages for each SSE increase gradually, PLRin increases slightly and PLRout increases gradually. At the maximum point of shaft efficiency, the losses of the SSE with 2.95 are 28.06 kPa and 46.09 kPa, and the values of the SSE with 3.98 are 37.58 kPa and 33.79 kPa, respectively. It shows that the pressure losses are relatively high. The maximum values of internal and external expansion ratio for the SSE with 2.95 are 4.8 and 6 respectively, and the values of the SSE with 3.98 are 5.7 and 7 respectively. For ideal volume expansion, the internal expansion ratio of two prototypes should be 4.55 and 6.9, respectively. Summarizing the above results, how to enhance the pressure drop effect of leakage and reduce the flow resistance loss of inlet and exhaust passages simultaneously is an important technical premise to improve the expansion ratio by structural optimization. Meanwhile, PELRe of two prototypes are 16.01% and 13.59% respectively at the point. It shows that the flow losses of inlet and exhaust passages could significantly influence the performance of SSEs.

The Research on Internal Leakage and Lubrication Property of Gap in Rotary Pressure Exchanger

Performance Analysis of the Cylinder Gas Film Seal between Dual-Rotor Reverse Shafts Considering Lubrication and Centrifugal Expansion Effects

Experimental Research on Energy Recovery Efficiency and the Leakage Characteristic of Rotary Pressure Exchanger

Performance Study of a Rotary Vane Pressure Exchanger for SWRO

Experimental Research on Pressure Loss of Rotary Pressure Exchanger

Modeling and Experimental Investigation on the Internal Leakage in a CO2 Rotary Vane Expander

Investigation into the lubricating gap between the ring gear and the case in internal gear pumps

Research and Analysis on the Radial Clearance Leakage for Translational Rotary Compres-sors

Numerical investigations on the leakage flow characteristics of pocket damper labyrinth seals

Research on the Influence of Lateral Force and Pressure Fluctuation on the Stability of a Rotary Energy Recovery Device in the Desalination System

Study on Leakage via the Radial Clearance in a Double Vane Ellipse Rotor Compressor

Numerical and experimental research on the integrated energy recovery and pressure boost device for seawater reverse osmosis desalination system

Unsteady Leakage Flow Through Axial Clearance of an ORC Scroll Expander

Research on Leakage of Translational Rotary Compressor

Analysis and Experimental Study on the Characteristics of Leakage of Rotary Seal Using Sealing Ring

Experimental study on the influence of inlet and exhaust pressure loss on the performance of single screw expanders

Steady-State Flow Characteristics and End Clearance Optimization of Internal Gear Grease Pump

Numerical Research on the Hydrodynamic Effect on the Leakage of Two-Phase Refrigerant-Oil Mixture in the Flank Gaps of Compressors

Research of Leakage Characteristics of Single Screw Refrigeration Compressors with the Multicolumn Envelope Meshing Pair

Analysis of axial leakage in high pressure involute internal gear pump

Research on internal flow field analysis and power loss modeling of the expansion seal ring