Abstract:The tangential impingement of turbulent circular jets on the cylindrical surface in an annular chamber is numerically investigated based on the SAS-SST model. The main purpose is to understand the role of the coherent structures on the temperature field inside the chamber and the heat transfer coefficient field on the hub surface. Based on the jet diameter and inlet velocity, the jet Reynolds numbers are given as 285000, 332000, and 392000, respectively. The accuracy of the numerical simulation is verified by the experimental data. The spectrum information of the velocity magnitude at the monitor point is obtained by the fast Fourier transform (FFT) method. An improvement of the proper orthogonal decomposition (POD) method is known as the extended POD (EPOD) method, which is mainly suitable for analyzing the correlation between the flow field and the synchronized scalar or vector fields, such as the correlation between the velocity and the heat transfer coefficient fields. In present study, both the POD method and the EPOD method are applied and compared. The POD method allows to visualize the main modes in terms of velocity, temperature, and heat transfer coefficient fluctuations. With the help of the EPOD method, the contribution of velocity fluctuations to temperature fluctuations in the chamber and heat transfer fluctuations on the hub surface are further analyzed. For Rej = 392000, the first two velocity POD modes and the velocity EPOD modes that contribute the most to the temperature fluctuations are very similar, reflecting the same large-scale coherent structures. The first two velocity EPOD modes that contribute the most to the heat transfer coefficient fluctuations have a high proportion of energy in the flow field, corresponding to the deflection motion of the jet.

Experiments on the vorticity distribution behind the small panel

Vorticity Measurements Using a 6-Sensor Hot-Wire Probe in a Tangentially Fired Furnace

THREE-DIMENSIONAL MOTION OF VORTICES IN THE PLATEN ZONE OF TANGENTIALLY FIRED FURNACE

Vorticity Measurements in Complex 3-D Flow in Tangentially-Fired Furnaces

COHERENT STRUCTURE VORTICES ON THE FIRE-FACING SIDE OF FOUR BURNER JETS

Mathematical model on flow around multi-platen in the tangentially-fired furnace

THE RESEARCH OF THE CAUSE OF VELOCITY IMBALANCE IN A TANGENTIALLY-FIRED FURNACE

The Experiment Research of the Influence of the Structure of the Panel Zone on Gas Velocity Deviation in a Tangentially-Fired Boiler

Experimental and Numerical Study on Temperature Variation and Air Flow Distribution in Trapped Votex Combustor

Phase-average Analysis of Three-Dimensional Vorticity and Temperature Dissipation Rate in the Near Field of a Heated Circular Cylinder Wake

Spectrum Analysis on the Character Frequency for Turbulent Flow in Tangentially Fired Furnace

Scale and Rotating Velocity of a Big Shear Vortex at the Fire-facing Side of a Burner Region in a Large-sized Utility Boiler

Contradistinction of Cold Modeling Tests and Hot Modeling Test for Gas Flow in T-Fired Furnace

Experimental and numerical study on the flow fields in upper furnace for large scale tangentially fired boilers

NUMERICAL STUDY ON THE CONTRARY MODES OF AIR JETS IN A LARGE FURNACE

D209 EXPERIMENTAL RESEARCH OF TEMPERATURE DISTRIBUTION IN FURNACE WITH SWIRL BURNERS

Experimental and numerical studies on the gas velocity deviation in a 600 MWe tangentially fired boiler

An experimental comparison of the airflow characteristics of four-walls tangential firing and four-corners tangential firing

EXPERIMENTAL STUDY OF JET CHARACTERISTICS OF HBC-SSA BURNER IN TANGENTIALLY FIRED FLOW FIELD

The Heat Transfer and Coherent Structures of the Tangential Impingement Jets in the Annular Chamber Studied with Extended Proper Orthogonal Decomposition

Experimental Study of Aerodynamic Characteristics in a W-shaped Flame Boiler Equipped with a Bin and Feeder System aud Fed Tertiary Hot Air in the Boiler Furnace