Abstract:Modern heating furnaces use combined modes of heating the charge. At high heating temperatures, more radiation heating is used; at lower temperatures, more convection heating is used. In large heating furnaces, such as pusher furnaces, it is necessary to monitor the heating of the material zonally. Zonal heating allows the appropriate thermal regime to be set in each zone, according to the desired parameters for heating the charge. The problem for each heating furnace is to set the optimum thermal regime so that at the end of the heating, after the material has been cross-sectioned, there is a uniform temperature field with a minimum temperature differential. In order to evaluate the heating of the charge, a mathematical model was developed to calculate the heat fluxes of the moving charge (slabs) along the length of the pusher furnace. The obtained results are based on experimental measurements on a test slab on which thermocouples were installed, and data acquisition was provided by a TERMOPHIL-stor data logger placed directly on the slab. Most of the developed models focus only on energy balance assessment or external heat exchange. The results from the model created showed reserves for changing the thermal regimes in the different zones. The developed model was used to compare the heating evaluation of the slabs after the rebuilding of the pusher furnace. Changing the furnace parameters and altering the heat fluxes or heating regimes in each zone contributed to more uniform heating and a reduction in specific heat consumption. The developed mathematical heat flux model is applicable as part of the powerful tools for monitoring and controlling the thermal condition of the charge inside the furnace as well as evaluating the operating condition of such furnaces.

Mathematical model on flow around multi-platen in the tangentially-fired furnace

THREE-DIMENSIONAL MOTION OF VORTICES IN THE PLATEN ZONE OF TANGENTIALLY FIRED FURNACE

THE RESEARCH OF THE CAUSE OF VELOCITY IMBALANCE IN A TANGENTIALLY-FIRED FURNACE

NUMERICAL MODELING OF 3-D ISOTHERMAL FLOW IN TANGENTIALLY-FIRED BOILER WITH BODY-FITTED MESHES

Experimental and numerical study on the flow fields in upper furnace for large scale tangentially fired boilers

Vorticity Measurements Using a 6-Sensor Hot-Wire Probe in a Tangentially Fired Furnace

Vorticity Measurements in Complex 3-D Flow in Tangentially-Fired Furnaces

Experiments on the vorticity distribution behind the small panel

Modeling of Heat Flux in a Heating Furnace

Numerical Study of the Effect of Imaginary Circle Diameter and Initial Flow Field on the Aerodynamic Field in a Tangentially Fired Furnace

COHERENT STRUCTURE VORTICES ON THE FIRE-FACING SIDE OF FOUR BURNER JETS

Mathematical model of thermal process in complex structure furnace with nonhomogeneous medium

NUMERICAL STUDY ON THE CONTRARY MODES OF AIR JETS IN A LARGE FURNACE

Mathematical Model of a Heating Furnace Implemented with Volumetric Fuel Combustion

CFD investigation on the flow and combustion in a 300 MWe tangentially fired pulverized-coal furnace

Numerical Analysis of Fluid Flow and Heat Transfer by Means of a Unified Model in a Direct Current Electric Arc Furnace

Computational modeling of pulverized coal combustion processes in tangentially fired furnaces

Computational Modeling of Tangentially Fired Boiler (I) Models, Flow Field and Temperature Profiles

Contradistinction of Cold Modeling Tests and Hot Modeling Test for Gas Flow in T-Fired Furnace

Three-dimensional modelling of the wall heat transfer in the lower stack region of a blast furnace