Abstract:Composite materials may be subjected to extreme conditions where the surface is exposed to high-energy photon radiation, which can significantly change material properties and even cause severe damage and destruction. While the interaction of high-energy photons with homogeneous materials has been well studied, it is still a challenge to model the photon transport in composite materials. In this study, we propose a Monte Carlo model to simulate the photon transport in structurally and chemically heterogeneous materials. The model is first verified and validated by comparison with an existing open-source software (Geant4) through a case study of calculating the photon energy deposition curve in aluminum. It is then applied to studying the photon energy deposition in carbon fiber reinforced polymer (CFRP), of which the simulation results show a highly heterogeneous pattern of energy deposition in carbon fibers and epoxy resins. We also calculate the energy deposition in CFRP by homogenizing the composite as a single-phase material and compare the results with those of the full-field Monte Carlo simulations. It is found that energy deposition calculation based on homogenization can result in significant errors when the photon energy is high and is thus only suitable for low-energy photon radiation. As a final demonstration, we apply the model to calculating the energy deposition of photons in composite metal foam (CMF). The simulation results show that most of the photon energy is absorbed by the sphere wall and only a small fraction is deposited in the matrix, leading to greatly improved shielding performance of CMF as compared to that of pure matrix metals. We believe that this model has the potential to be applied to composite materials design where the structural and material heterogeneity can be optimized for improved performance under radiation environment.

Accurate Monte Carlo Simulation of Electron Energy Deposition in Extended Media

Monte Carlo Simulation Study of Quasi-Elastic Electron Scattering from an Overlayer/Substrate System

Monte Carlo Calculation of Electron Rutherford Backscattering Spectra and High-Energy Reflection Electron Energy Loss Spectra

Modelling energy deposition in polymethyl methacrylate with low-energy electron irradiation

Monte Carlo Simulation of Incident Electrons Passing Through Thin Metal Layer

Numerical simulation of metal evaporation based on the kinetic model equation and the direct simulation Monte Carlo method

The Monte Carlo Simulation of the High Energy Ions Transport in Materials

Monte-Carlo simulation of sub-cellular level ionizing energy deposition

Monte Carlo Simulation Study of Electron Interaction with Solids and Surfaces

The Computing and Simulation of Energy Loss Performance for Deuteron in Different Target

APPLICATIONS OF EGSnrc MONTE CARLO SYSTEM IN CALCULATIONS OF DOSE DISTRIBUTION IN MATERIALS IRRADIATED BY ELECTRON BEAM AND OPTIMIZATION OF ELECTRON RADIATION PROCESSING

Monte Carlo simulations of charged particle transport in plasmas: A fast single-scattering model

The Research of Calculation Methods for Mean Energy in Electron Beams in Homogeneous Water Phantom

A Method for Calculating Electron-Energy Deposition in Thick Media

Monte Carlo Simulation of High-Energy Electron Beam Lithography Process

Modeling Photon Transport in Composite Materials Using Monte Carlo Algorithm

Research on Secondary Electron Emission Characteristics of Metal Materials Based on Monte-Carlo Simulation

Monte Carlo Method for Calculating Particle Radiation Detector Correction Factors

Electron Backscattering Coefficients of Molybdenum and Tungsten Based on the Monte Carlo Simulations

Energy Deposition Calculations in Dose Measurements of 0.2–3.0 MeV Electrons

Electronic Energy Loss Assessment in Theoretical Modeling of Primary Radiation Damage in Tungsten