Abstract:The thread and spline synchronous rolling (TSSR) process is a new developed rolling process, which can form the different profiles simultaneously in the process and can ensure the consistency of the relative position of different profiles of parts. However, the multi-meshing motions are intercoupling and the multi-deformation characteristics are intercoupling during the forming process. It can easily result in dimension overshoot, and even does not make the synchronous rolling process go smoothly. Exploring the influence of controllable processing parameters on the synchronous rolling process, especially the geometric parameters of rolled parts, is helpful to determine the parameters and control the size error for a smooth rolling process. Thus, in this paper, the effects of controllable geometric parameters and motion parameters such as billet diameter, radial feed-in speed, and rotational speed of synchronous rolling die on the TSSR process have been studied. The synchronous rolling experimental scheme was determined using an orthogonal experimental design method, and the geometric parameters of different tooth profiles of rolled parts were measured and analyzed. The experimental results indicated that: the uncoordinated meshing movement between different tooth profiles is more likely to cause tooth error of the splined section of the part; variations of the processing parameters are more likely to cause fluctuations in the size of the splined section of the part, and change of the billet diameter mainly affects the outside diameter of the threaded and splined sections, and the threaded and splined pitches are mainly affected by the motion parameters of the synchronous rolling die; the motion parameters of the rolling die should be matched and the lower rotational speed needs to match the lower radial feed-in amount per revolution; the ideal dimensional accuracy can be obtained by using an appropriate processing parameter combination, for example, the pitch error of the splined section of the part is less than 0.5 μm under one set of experimental conditions in this paper.

Research Status of High Efficiency Forming Shaft Parts Having Thread and Spline Coaxially by Synchronous Rolling

New method for forming shaft having thread and spline by rolling with round dies

Discussion on the High-efficiency High-performance Precise Rolling Forming Process and Equipment of Shaft Parts with Complex Shape

Die Structure and Its Trial Manufacture for Thread and Spline Synchronous Rolling Process

Implementing approach of rolling process for inner spline sleeve with medium diameter: radial-feed rolling and through-feed rolling

Improvement of Axial Forging Process for Spline Shaft by Die Design

Influence of Processing Parameters on the Thread and Spline Synchronous Rolling Process: an Experimental Study.

Finite element modeling and analysis for the integration–rolling–extrusion process of spline shaft

The Experimental Study of Axial In-feed Incremental Rolling Process of Spline Shaft

Experimental Study on the Axial-Infeed Incremental Warm Rolling Process for Spline Shaft Production

The Importance of Forming Parameters on Rolling Process and the Performances of Component in Forming Long Threads

Analysis of Forming Error During Thread and Spline Synchronous Rolling Process Based on Motion Characteristic

Numerical Analysis on the Power-Type Incremental Rolling Forming Process of Spline Shaft

Analysis and Prospect of Precision Plastic Forming Technologies for Production of High-Speed-Train Hollow Axles

Deformation Mechanism and Performance Improvement of Spline Shaft with 42crmo Steel by Axial-Infeed Incremental Rolling Process

Finite element analysis on axial-pushed incremental warm rolling process of spline shaft with 42CrMo steel and relevant improvement

Investigation on Rationality of High-Efficient Precision and Batch Production Process for Spline Shaft

Theoretical Analysis and Numerical Simulation of External Spline Cold Rolling

Analysis of Motion Between Rolling Die and Workpiece in Thread Rolling Process with Round Dies

Cold-extrusion Die Design of Subsidiary Transmission Shaft

Numerical and Experimental Analysis of Deformation Behaviors and Microstructure Evolution in the Thread Rolling Process