Abstract:Since cross-anisotropic sand behaves differently when the loading direction or the stress state changes, the influences of the loading direction and the intermediate principal stress ratio (b = (σ2 − σ3)/(σ1 − σ3)) on the initiation of strain localization need study. According to the loading angle (angle between the major principal stress direction and the normal of bedding plane), a 3D non-coaxial non-associated elasto-plasticity hardening model was proposed by modifying Lode angle formulation of the Mohr–Coulomb yield function and the stress–dilatancy function. By using bifurcation analysis, the model was used to predict the initiation of strain localization under plane strain and true triaxial conditions. The predictions of the plane strain tests show that the major principal strain at the bifurcation points increases with the loading angle, while the stress ratio decreases with the loading angle. According to the loading angle and the intermediate principal stress ratio, the true triaxial tests were analyzed in three sectors. The stress–strain behavior and the volumetric strain in each sector can be well captured by the proposed model. Strain localization occurs in most b value conditions in all three sectors except for those which are close to triaxial compression condition (b = 0). The difference between the peak shear strength corresponding to the strain localization and the ultimate shear strength corresponding to plastic limit becomes obvious when the b value is near 0.4. The influence of bifurcation on the shear strength becomes weak when the loading direction changes from perpendicular to the bedding plane to parallel. The bifurcation analysis based on the proposed model gives out major principal strain and peak shear strength at the initiation of strain localization; the given results are consistent with experiments.

STRAIN LOCALIZATION ANALYSIS OF ANISOTROPIC SANDS BASED ON NON-COAXIAL THEORY

Hypoplastic Modeling of Anisotropic Sand Behavior Accounting for Rotation of Principal Stress Direction

Non-coaxial hypoplastic model for sand with evolving fabric anisotropy including non-proportional loading

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

A Multiscale Investigation of Strain Localization in Cohesionless Sand

Effect Of Non-Coaxiality On Dilatancy Of Sand Involving Principal Stress Axes Rotation

Unified Modeling of the Influence of Consolidation Conditions on Monotonic Soil Response Considering Fabric Evolution

Constitutive Modeling of Physical Properties of Coastal Sand During Tunneling Construction Disturbance

Influences of loading direction and intermediate principal stress ratio on the initiation of strain localization in cross-anisotropic sand

The mechanisms of non-coaxial deformation for anisotropic sand under fixed principal stress axes shearing

Three‐dimensional Anisotropic Plasticity Model for Sand Subjected to Principal Stress Value Change and Axes Rotation

A thermodynamic critical state model for sands

Experimental Investigation of Asymptotic State for Anisotropic Sand

An Anisotropic Critical State Plasticity Model with Stress Ratio-Dependent Fabric Tensor

On strain localization of aeolian sand in true triaxial apparatus

Small Strain Path-Dependent Stiffness of Toyoura Sand: Laboratory Measurement and Numerical Implementation

AN ELASTOPLASTIC CONSTITUTIVE MODEL OF SANDS CONSIDERING CYCLIC ROTATION OF PRINCIPAL STRESS AXES

An Anisotropic Plasticity Model Incorporating Fabric Evolution for Monotonic and Cyclic Behavior of Sand

A novel constitutive model of the anisotropic sand accounting for the fabric evolution

Experimental Study on Asymptotic Behaviour of Anisotropic Sand

Modeling Strain-Rate Dependent Behavior of KR0-Consolidated Soft Clays