Abstract:In practical engineering, cyclic shear stresses induced by earthquakes, traffic, and waves are superimposed on the initial static shear stress in sand fills or deposits, leading to complex responses of soils such as their deformation characteristics, pore pressure generation, and susceptibility (or cyclic resistance) to liquefaction. To experimentally investigate the undrained cyclic response of saturated sand, a series of triaxial tests were performed, covering a broad range of initial static and cyclic deviatoric stress levels. The results indicate that different stress conditions lead to two types of cyclic behavior: cyclic mobility and residual deformation accumulation. The compressional static stress is beneficial to the cyclic resistance of the dense sand, whereas the extensional static stress is regarded as detrimental as it tended to reduce the cyclic strength. Moreover, by comparing the available test data obtained from the same sand with varying initial densities and confining pressures, the static shear effect on cyclic resistance was found to be dependent on the state of the sand. Compared to the interpretation made using the limiting pore pressure-based criterion, the conventional failure criterion using a cyclic axial strain of 5% may lead to a substantial overestimation of the cyclic resistance, thus resulting in unsafe assessment and design. Hence, by employing the pore pressure criterion, the pore pressure generated in the cyclic tests was investigated and was found to be significantly influenced by the static shear stress. A pore pressure generation model is proposed to obtain the pore pressure characteristics of sand under various static shear stress conditions.

AN ELASTOPLASTIC CONSTITUTIVE MODEL OF SANDS CONSIDERING CYCLIC ROTATION OF PRINCIPAL STRESS AXES

Hypoplastic Modeling of Anisotropic Sand Behavior Accounting for Rotation of Principal Stress Direction

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Non-coaxial hypoplastic model for sand with evolving fabric anisotropy including non-proportional loading

Flow Deformation and Cyclic Resistance of Saturated Loose Sand Considering Initial Static Shear Effect

Hypoplastic Model for Sand under Multidirectional Shearing Conditions Considering Fabric Change Effect

Cyclic accumulative deformation of sand and its explicit model

AN ELASTOPLASTIC MODEL FOR SAND CONSIDERING DISTURBANCE

Drained Deformation Behavior of Anisotropic Sands during Cyclic Rotation of Principal Stress Axes

Permanent Deformation Characteristics of Saturated Sand under Cyclic Loading

Deformation Behavior of Sands Subjected to Cyclic Rotation of Principal Stress Axes

Effects of cyclic rotation of principal stress axes and intermediate principal stress parameter on the deformation behavior of sands

Effect Of Non-Coaxiality On Dilatancy Of Sand Involving Principal Stress Axes Rotation

Three‐dimensional Anisotropic Plasticity Model for Sand Subjected to Principal Stress Value Change and Axes Rotation

An elastic–viscoplastic constitutive model incorporating shear dilation characteristic

A Cyclic Elasto-Plastic Constitutive Model for Evaluating Large Liquefaction-Induced Deformation of Sand

A thermodynamic critical state model for sands

Calibration and validation of a sand model considering the effects of wave-induced principal stress axes rotation

SAND RESPONSE TO CYCLIC ROTATION OF PRINCIPAL STRESS DIRECTIONS AS INDUCED BY WAVE LOADS

Three-dimensional multi-mechanism bounding surface model for sands