Abstract:To explore the nature of cyclic stress alteration in seabed deposits of sand due to travelling waves, two-dimensional stress analysis was carried out on a homogeneous elastic half-space subjected to a series of harmonic loads moving on its surface. The analysis indicated that changes in shear stress occur in such a way that, while its amplitude is maintained constant, the directions of the principal stresses rotate continuously. With a view to simulating such stress changes in the laboratory test, a series of cyclic triaxial torsion shear tests was conducted on loose specimens of sand. The test results indicated that the conventionally defined cyclic stress ratio is reduced by about 30 per cent if the rotation of the principal stress directions is involved in the cyclic loading. It is known that the magnitude of wave-induced pressure at the seabed changes as ocean waves move in towards the shore. In unison with the changes in the pressure wave, the cyclic stress ratio induced in the seabed also changes. However, owing to the wave breaking, there exists an upper limit in the magnitude of the wave pressure and, hence, in the induced cyclic stress ratio. With these characteristics in mind, a set of charts was provided to facilitate computation of the induced cyclic stress ratio in the seabed deposit of water of any depth, on the assumption that the seabed consists of a homogeneous isotropic elastic half-space. The charts are organized so that the induced cyclic stress ratio can be obtained for known wave parameters that are specified by design storms at an offshore location. The cyclic stress ratio thus obtained was compared with the corresponding cyclic stress ratio causing failure in the sand, which was determined in the laboratory with a cyclic triaxial torsion shear test equipment in which continuous rotation of the principal stress direction was executed in simulation of the wave-induced stress conditions occurring in the seabed deposit.

SAND RESPONSE TO CYCLIC ROTATION OF PRINCIPAL STRESS DIRECTIONS AS INDUCED BY WAVE LOADS

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Undrained Behavior of Sand under Cyclic Paths That Match Storm-Wave Loading Conditions

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Hypoplastic Modeling of Anisotropic Sand Behavior Accounting for Rotation of Principal Stress Direction

Flow Deformation and Cyclic Resistance of Saturated Loose Sand Considering Initial Static Shear Effect

Energy-Based Approach to Quantify Cyclic Resistance and Pore Pressure Generation in Anisotropically Consolidated Sand

Discrete-Element Simulation of Dense Sand under Uni- and Bidirectional Cyclic Simple Shear Considering Initial Static Shear Effect

Wave-induced Liquefaction in Seabed Deposits of Sand

Permanent Deformation Characteristics of Saturated Sand under Cyclic Loading

Cyclic accumulative deformation of sand and its explicit model

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

Cyclic response of natural soft marine clay under principal stress rotation as induced by wave loads

Deformation Behavior of Sands Subjected to Cyclic Rotation of Principal Stress Axes

Drained Deformation Behavior of Anisotropic Sands during Cyclic Rotation of Principal Stress Axes

Effect of Drained Static Shear on Cyclic Deformation Behavior of K-0-consolidated Sand

Flow Deformation of Sands Subjected to Principal Stress Rotation

Undrained Cyclic Response and Resistance of Saturated Calcareous Sand considering Initial Static Shear Effect

Effect Of Non-Coaxiality On Dilatancy Of Sand Involving Principal Stress Axes Rotation

Experimental study on the influence of principal stress axes rotation on sand mechanical behavior and non-coaxiality effects

AN ELASTOPLASTIC CONSTITUTIVE MODEL OF SANDS CONSIDERING CYCLIC ROTATION OF PRINCIPAL STRESS AXES