Abstract:Multimode fibers are attractive for high-power lasers if transverse modes are efficiently controlled. Here, a dielectric thin-film mirror (R~20%) is micro-fabricated on the central area of the end face of a 1 km multimode 100/140 µm graded-index fiber and tested as the output mirror of a Raman laser with highly multimode (M2~34) 940 nm diode pumping. In the cavity with highly reflective input FBG, Raman lasing of the Stokes wave at 976 nm starts at the threshold pump power of ~80 W. Mode-selective properties of mirrors with various diameters were tested experimentally and compared with calculations in COMSOL, with the optimum diameter found to be around 12 µm. The measured Raman laser output beam at 976 nm has a quality factor of M2~2 near the threshold, which confirms a rather good selection of the fundamental transverse mode. The power scaling capabilities, together with a more detailed characterization of the output beam's spatial profile, spectrum, and their stability, are performed. An approximately 35 W output power with an approximately 60% slope efficiency and a narrow spectrum has been demonstrated at the expense of a slight worsening of beam quality to M2~3 without any sign of mirror degradation at the achieved intensity of >30 MW/cm2. Further power scaling of such lasers as well as the application of the proposed technique in high-power fiber lasers are discussed.

Research on the Radial Polarization Laser Reflection Cavity Mirror

Design, Fabrication and Characterization of Dispersive Mirrors for Ultrafast Lasers

Design of Ultrabroadband Double-Chirped Mirror Pairs for Ultrafast Lasers

Theoretical Analysis of Periodically Poled LiNbO3 Nonlinear Mirror and Its Application in a Passively Mode-Locked Nd:YSAG Laser

High-dispersive Mirror for Pulse Stretcher in Femtosecond Fiber Laser Amplification System

Nd:YAG/Cr~(4+) :YAG Passive Mode-Locking Laser with Corner Cube Prism Resonator

Research on 2 Μm Polarization Maintaining Laser Cavity Based on the Depolarization Characteristics of a Corner Cube Prism

Research Advances in Mode-Locked Fiber Lasers Based on Nonlinear Loop Mirror

Ultrahigh-Reflectivity Circularly Polarized Mirrors Based on the High-Contrast Subwavelength Chiral Metasurface

Radially Polarized Orbital Angular Momentum Beam Emitter Based on Shallow-Ridge Silicon Microring Cavity

Raman Lasing and Transverse Mode Selection in a Multimode Graded-Index Fiber with a Thin-Film Mirror on Its End Face

Cr:Yag Passively Q-Switched Single-Frequency Nd:Yvo4 Ring Cavity Laser

Design and Fabrication of 1300-Line/mm Polarization-Independent Reflection Gratings for Spectral Beam Combining

A High Performance Polarization Independent Reflector Based on A Multilayered Configuration Grating Structure

Numerical simulation and optimization of beam quality of 2.1 μm Cr, Tm, Ho: YAG laser with symmetric spherical resonator based on gradient-reflectivity mirror

Design of a High-Efficiency Multilayer Dielectric Diffraction Grating with Enhanced Laser Damage Threshold

Design and analysis of broadband guided-mode resonant reflectors with coated triangular and trapezoidal profiles in TE polarization

Design and fabrication of super-Gauussian laser mirror

Optimized Si/SiO2 high contrast grating mirror design for mid-infrared wavelength range: robustness enhancement

Asymmetric ${\rm TEM}_{00}$ -Mode Cavity for Birefringence-Compensated Two-Rod Solid-State Lasers

Thermal-Induced Birefringence-Compensated Laser System with Two Nd∶ YAG Rods