Failure evaluations for packers in multistage fracturing technology with immobile strings
Yue Qian-bei,Wang Xiao-xiao,Liu Yue-qiu,Cao Wen,Zhang Qiang
DOI: https://doi.org/10.1016/j.petrol.2021.109039
IF: 5.168
2021-11-01
Journal of Petroleum Science and Engineering
Abstract:With the development of unconventional oil and gas resources, the multi-stage fracturing technology with immovable string has been developed rapidly due to its advantages of large construction capacity and multiple fracturing stages. But the failure of packer has become a bottleneck restricting the development of technology. In this paper, the mechanical properties of corroded ((under the environment of I(North Troyes),II(Jeannajor) and III(Khasib)) ) and uncorroded rubber of the packer were tested by designed experiments at first. The experimental values showed that elastic modulus, shear strength and tensile strength decreased when packers were corroded. Then, according to packers' structure and load characteristics, taking the rubber cylinder, rubber support, center pipe, tubing and string as research object, the dynamic model was established for tubes and packers in fracturing layers. Based on conditions of the shear strength, pressure seal and axial movement for rubber cylinder, the safety evaluation method was proposed for packer sealing system. And the failure evaluation of multistage fracturing packer in Gao182-151 well in Daqing Field was carried out by the method established in this paper. At last, we could get the following results: the sealing safety coefficients of upper and lower packers were all greater than 1.0 during the fracturing process of layer I to IV. The axial displacement of the packer's rubber of the non-corrosive and corrosivewere all 0.00. So the packers were sealed well in each stage of fracturing, and no leakage accidents occurred during the entire fracturing process of Gao 182-151 Well. But in the fracturing layer I, the shear safety factor of the corroded (under corrosive environment of I(North Troyes),II(Jeannajor) and III(Khasib)) rubber were is 1.00, 1.10, 0.99 respectively. The shear strength was less than or equal to 1.10 and it didn't not satisfy the shear strength. Therefore, we could get the conclusion that the corroded rubber did not meet the shear strength and rubber tearing was prone to occur in the fracturing layer I. So it is recommended to replace the rubber with a new one before the construction of Gao 182-151Well.
energy & fuels,engineering, petroleum