Abstract:The paper presents an experimental program on a structural system, consisting of three long-span portal frames. The primary structural members, including columns and rafters, were constructed using cold-rolled aluminium back-to-back built-up channel sections. The system configuration featured two bays of single-span cold-rolled aluminium portal frames connected in parallel by a series of purlins spanning between the rafters to create a free-standing structure. A total of three full-scale tests (Frame Tests 1,2 & 3) were conducted with two loading scenarios. Frame Tests 1&2, which were identical to ensure accuracy, were subjected to vertical loads only, while Frame Test 3 underwent testing with combined horizontal and vertical loads. In all the tests, the columns were unbraced. The main objectives of this paper are, first, to describe the test setups and observe the structural behaviours of the portal frame systems. Consequently, the ultimate capacities were determined, and the predominant failure modes of the portal systems were identified as flexural-torsional buckling of the unbraced columns. The paper also provides information on the mechanical properties of the aluminium alloy 5052-H36 materials used to fabricate the structural members and frame components, obtained from compressive and tensile coupon tests. Further, the elastic buckling loads of the columns in the frame systems are reported in this paper, as determined from the measured load-deformation curves. While this paper primarily delves into the behaviour of the cold-rolled aluminium portal frames with a focus on flexural torsional buckling failures of unbraced columns, the authors have also conducted a separate study on the same system. In that separate study, the portal frames with the columns predominantly restrained against flexural-torsional buckling were investigated to enhance the ultimate capacities of the portal frame systems.

Experimental and Theoretical Investigation to Uhimate Load-Carrying Capacity of a Steel Portal Frame with Tapered Members

ULTIMATE LOAD-CAPACITY ANALYSIS OF LIGHT-WEIGHT STEEL PORTAL FRAMES UNDER WIND AND SNOW LOADING

Pushover Analysis of Light-Weight Steel Portal Frame Structures under Strong Wind Loading

Wind-resistant safety analysis of light-weight steel portal frame structures

Experimental study and capacity analysis of double-tapered rectangular steel tubes

Effect of Shear Deformation in Latticed Columns on Buckling of Heavily Loaded Industrial Portal Frames

Experimental Investigation into Flexural Buckling of Double-Limb Built-Up Plate Members under Compression

Experimental Investigation of Circular Steel Tubes with Tapered Ends Subjected to Bending,compression and Torsion

EXPERIMENTAL RESEARCH AND FINITE ELEMENT ANALYSIS ON A WELDED JOINT WITH TUBES INTERSECTED AT TWO DIFFERENT POINTS

Inelastic Storey-Buckling Factor of Steel Frames

Experimental Study of Bearing Capacity of Steel Frame with Portal Steel Plate Shear Wall Member

In-plane ultimate load-carrying capacity of tapered I columns

Study of the Mechanical Properties of Beam-Column Joints in a New Type of Aluminum Alloy Portal Frame

Arranging the Plastic Hinges and Improving the Strength of Steel Tubes with Tapered Ends: Analysis and Tests

Experimental investigation of long-span cold-rolled aluminium built-up section portal frames: Unbraced columns and flexural-torsional buckling

Design and Analysis of Long-span Portal Frame Steel Structures with Prestressed Cable-strut

Experimental and Analytical Study on Local Buckling Behavior of High Strength Steel Welded I-Section Beams

Experimental Study on the Bearing Capacity of Full-scale Cuplok Steel Tubular Supporting Frame

Investigation and Analysis of Total Collapse of a Portal Frame Structure with Large Span

Experimental study on large deflections of beam–column joints with reinforced flange plates

Static Load Experimental Investigation to Model of Cable- Strut Portal Frame