Abstract:In order to clarify the effect of particle coagulation on the heat transfer properties, the governing equations of nanofluid together with the equation for nanoparticles in the SiO2/water nanofluid flowing through a turbulent tube are solved numerically in the range of Reynolds number 3000 <= Re <= 16,000 and particle volume fraction 0.005 <= phi <= 0.04. Some results are validated by comparing with the experimental results. The effect of particle convection, diffusion, and coagulation on the pressure drop increment P, particle distribution, and heat transfer of nanofluid are analyzed. The main innovation is that it gives the effect of particle coagulation on the pressure drop, particle distribution, and heat transfer. The results showed that increment P increases with the increase in Re and phi. When inlet velocity is small, the increase in increment P caused by adding particles is relatively large, and increment P increases most obviously compared with the case of pure water when the inlet velocity is 0.589 m/s and phi is 0.004. Particle number concentration M-0 decreases along the flow direction, and M-0 near the wall is decreased to the original 2% and decreased by about 90% in the central area. M-0 increases with increasing Re but with decreasing phi, and basically presents a uniform distribution in the core area of the tube. The geometric mean diameter of particle GMD increases with increasing phi, but with decreasing Re. GMD is the minimum in the inlet area, and gradually increases along the flow direction. The geometric standard deviation of particle diameter GSD increases sharply at the inlet and decreases in the inlet area, remains almost unchanged in the whole tube, and finally decreases rapidly again at the outlet. The effects of Re and phi on the variation in GSD along the flow direction are insignificant. The values of convective heat transfer coefficient h and Nusselt number Nu are larger for nanofluids than that for pure water. h and Nu increase with the increase in Re and phi. Interestingly, the variation in phi from 0.005 to 0.04 has little effect on h and Nu.

Prediction of Minimum Fluidization Velocity of Silicon Particle System with the Pressure Fluctuation Method

Numerical simulation of pressure fluctuation in gas-solids agitated fluidized bed

Fluidization Characteristics of Silicon Particles with a Wide Size Distribution

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Modeling of the Minimum Fluidization Velocity and the Incipient Fluidization Pressure Drop in a Conical Fluidized Bed with Negative Pressure

Study on the Nature of Pressure Signals in a Bubbling Fluidized Bed

Minimum fluidization velocity of bimodal polyethylene particles

Prediction of minimum fluidization velocity in pulsed gas–solid fluidized bed

A Comparative Study of Electrostatic Current and Pressure Signals in a MSFC Gas–solid Fluidized Bed

Numerical simulation of granular silicon growth and silicon fines formation process in polysilicon fluidized bed

Agglomeration Parameters and Drag Coefficients in Agglomerate Particulate Fluidization of SiO_2 Nanoparticles

Particle Distribution and Heat Transfer of SiO<sub>2</sub>/Water Nanofluid in the Turbulent Tube Flow

Characterization of Gas–solid Fluidization in Fluidized Beds with Different Particle Size Distributions by Analyzing Pressure Fluctuations in Wind Caps

Pressure fluctuations in a fluidized bed of binary particles with significant differences in particle size

A Fitting Formula for Predicting Droplet Mean Diameter for Various Liquid in Effervescent Atomization Spray

Distribution of non-spherical nanoparticles in turbulent flow of ventilation chamber considering fluctuating particle number density

Characterization of Pressure Signals in Fluidized Beds Loaded with Large Particles Using Wigner Distribution Analysis: Feasibility of Diagnosis of Agglomeration

Hydrodynamic Behaviors of a Spouted Fluidized Bed with a Conical Distributor and Auxiliary Inlets for the Production of Polysilicon with Wide-Size-distribution Particles

Optimization of simulation model adaptability and CFD of particles of Geldart‐B in a gas–solid fluidized bed for silicone monomer synthesis

Experimental study on the solid velocity in horizontal dilute phase pneumatic conveying of fine powders

CFD-DEM analysis of particle polydispersity on the performance of fluidised bed reactor during silane pyrolysis