Applied Anatomy of the Scapula for Internal Fixation

叶林根,黄海华,周富根,汪伟,蒋国华,俞光荣,张凯
DOI: https://doi.org/10.3969/j.issn.1001-165x.2004.05.019
2004-01-01
Abstract:Objective: To provide information for hardware fixation and drill hole placement in the treatment of scapula fractures. Methods: 30 pieces of adult scapula specimen were studied. Linear measurements were made ,while a micrometer measurements of thickness were obtained by a depth gauge. Angular measurements were made by using a goniometer to measure the nearest degree. The overall average, Standard deviation, and range were determined for each of the measurements. Results: The average length of the scapular was 146.3±12.0 mm, the thickness of the medial border at 1 cm from the edge was 4.1±2.5 mm. Anteroposterior thickness of the neck of the scapula at 1 cm and 2 cm from the glenoid was 17.8±3.5mm and 13.4±3.1 mm respectively. The thickness of the lateral border at the point of 1/4,2/4,3/4 length of the lateral border from the surface was 13.5±5.8 mm,11.5±4.5 mm,8.6±5.0 mm respectively. The glenoid faced slightly posteriorly with a tilt angle of 5.6°±3.1°. Conclusions: The medial and lateral borders of the body have sufficient bone mass approximately lcm from the edge to support internai fixation, especially the lateral border which is the most important place for fixation. The glenoid tilt angle and the amount of bone in the neck of the scapula, are particular important in hardware fixation and drill hole placement
What problem does this paper attempt to address?