Abstract:This paper focuses on a liquid-phase CO2 hydrogenation process for methanol synthesis to enhance CO2 conversion. The feasibility of a liquid-phase CO2 hydrogenation process is comprehensively evaluated through a techno-economic analysis. The solvent tetraethylene glycol dimethyl ether is identified as one of the most favorable options following an analysis of the solubility data pertaining to various solvents and their influence on the reaction equilibrium of the substances within the system. The influence of process parameters, including temperature, pressure, solvent amount, and gas hourly space velocity (GHSV), on the conversion of CO2 and the selectivity for methanol is examined and optimized in a liquid-phase CO2 hydrogenation to methanol process without a gas recycle (Process 1), optimal reaction conditions are determined and a CO2 conversion of 95.19 % and a CH3OH yield of 94.77 % with a purity of 99.9 % are achieved. A liquid-phase process with a gas recycle (Process 2) is implemented to enhance the utilization of feed gas, achieving a CO2 conversion rate of 95.23 % and a methanol yield of 99.69 %. The liquid-phase process is further optimized by incorporating reactive distillation technology (Process 3), to enhance reaction efficiency and reduce energy consumption. Following the techno-economic evaluation, the energy efficiency of Process 3 is 7.79 % and 4.99 % higher than that of Process 1 and Process 2, respectively. The product cost of Process 3 is reduced by 8.75 % compared to Process 1 and by 4.25 % compared to Process 2. This research offers insights into the challenges associated with the development of the liquid-phase method.

Determination of gas-liquid mass transfer coefficient for methanol synthesis under supercritical condition

Simulation of Fluidized Bed Reactor for Methanol to Olefins(MTO)Process

Liquid-phase CO2 Hydrogenation to Methanol Synthesis: Solvent Screening, Process Design and Techno-Economic Evaluation

Liquid-Phase Methanol Synthesis Process at Supercritical State

Effects of Pore Structure on Methanol Selectivity in Carbon Monoxide Hydrogenation

Methanol Synthesis in Three-phase Agitated Reactor Using C302-2 Catalyst I. Influence of Operating Conditions on Methanol Synthesis

Mathematical Simulation of Methanol Synthesis in a Slurry Reactor

Study on the Methanol Synthesis in Slurry Reactors

Experimental study on methanol synthesis in impact reactor

Gas-Liquid Mass Transfer in A Slurry Bubble Column Reactor under High Temperature and High Pressure

Continuous Supercritical Low-Temperature Methanol Synthesis with N-Butane As A Supercritical Fluid

Catalytic esterification for carbon dioxide and methanol under supercritical condition

Discrimination of methanol desorption resistance relative to the reaction steps in presence of supercritical n -hexane

Continuous Production of Biodiesel Via Supercritical Methanol Transesterification in a Tubular Reactor. Part 1: Thermophysical and Transitive Properties of Supercritical Methanol

Numerical Simulation of CO Methanation for the Production of Synthetic Natural Gas in a Fluidized Bed Reactor

Study on Methanol Synthesis from Coal-Based Syngas

Absorption Enhanced Methanol Synthesis in a Trickle Bed Reactor over Cu/Zn/Al2O3 Catalyst

Selective Synthesis of Wax from Syngas by Supercritical Phase Process: Mass Transfer Effect of Co-Fed Olefin.

Intrinsic kinetics of methanol synthesis over catalyst SC309

Continuous preparation of biodiesel under supercritical methanol condition

Liquid-phase CO 2 hydrogenation to methanol synthesis: Solvent screening, process design and techno-economic evaluation