Abstract:It has been known for a long time that certain additives (e.g., NaCl, CaCl2, Na2CO3, Fe2O3) can increase the sulfur dioxide capture-capacity of limestones. In a recent study we demonstrated that very small amounts of Na2CO3 can be very beneficial for producing sorbents of very high sorption capacities. This paper explores what contributes to these significant increases. Mercury porosimetry measurements of calcined limestone samples reveal a change in the pore-size from 0.04-0.2 microm in untreated samples to 2-10 microm in samples treated with Na2CO3--a pore-size more favorable for penetration of sulfur into the particles. The change in pore-size facilitates reaction with lime grains throughout the whole particle without rapid plugging of pores, avoiding premature change from a fast chemical reaction to a slow solid-state diffusion controlled process, as seen for untreated samples. Calcination in a thermogravimetric reactor showed that Na2CO3 increased the rate of calcination of CaCO3 to CaO, an effect which was slightly larger at 825 degrees C than at 900 degrees C. Peak broadening analysis of powder X-ray diffraction data of the raw, calcined, and sulfated samples revealed an unaffected calcite size (approximately 125-170 nm) but a significant increase in the crystallite size for lime (approximately 60-90 nm to approximately 250-300 nm) and less for anhydrite (approximately 125-150 nm to approximately 225-250 nm). The increase in the crystallite and pore-size of the treated limestones is attributed to an increase in ionic mobility in the crystal lattice due to formation of vacancies in the crystals when Ca is partly replaced by Na.

Experiment Investigation of Influence of Characteristic of Sorbents on Their Sulfur Capture Capability

Effect of characteristic of sorbents on their sulfur capture capability at a fluidized bed condition

MICROSTRUCTURE AND SULFATION CHARACTERISTICS OF CALCIUM-BASED SORBENTS

Investigation of a Novel Composite Sorbent for Improved Sorption Characteristic

Experimental Investigation on Sulfur Transformation During Coal Steam Gasification with Ca-based Absorbent

An Investigation on Sulfation Mechanisms of Ca‐based Sorbent Modified by Sodium Salt

Modeling Investigation on the Characteristics of Pore Distributions of Calcium Based Sorbents

Modeling Investigation of Decomposition Properties of Calcium-Based Sorbent in High Temperature

[The Effect of Microstructure on the Desulphurization of Absorbents].

Desulfurization Test of Complex Captured Sulfur Agent in Lab

Experimental study on the desulphurization of shell and limestone

Effect of impurities on desulfurization properties of limestone during coal gasification

A THERMOGRAVIMETRIC STUDY ON SULFATION CHARACTERISTICS OF CALCIUM-BASED ABSORBENTS

An Investigation on Fractal Pore Structures and Sulfation Performances of Calcium-Based Sorbents

Study on the Factors Influencing Limestone Capturing Sulfur During Coal Combustion

Characterization of the enhancement effect of Na2CO3 on the sulfur capture capacity of limestones

An Experimental Study on Coal-Char Sorbents for Gas-Phase Mercury Removal from Flue Gas

Experimental Investigation on Desulfurization of Hydrolime

PORE SIZE DISTRIBUTION MODEL FOR SULFATION OF CALCIUM-BASED SORBENT

Study on desulfurization reaction characteristic of calcium-based sorbents

Experimental investigation on desulfurization of hygrolimebased on thermal balance