Abstract:In this paper, a high step‐up DC–DC converter based on coupled inductor with low input current ripple is presented. Also using a low power auxiliary circuit, turning on and off of the main switch, will be as soft switching. The soft switching condition is almost independent of the specifications of the circuit especially the output power and this is one of the advantages of suggested topology. In this paper, a new high step‐up DC–DC converter is presented. The presence of an inductor at converter input reduces input current ripple. Furthermore, a coupled inductor with a voltage multiplier cell is also implemented to increase the voltage gain of the converter. The stored energy in leakage inductance of coupled inductor is recycled by a clamp circuit which increases efficiency and clamps voltage on power switch. The power switch is turned on and off under soft switching condition. The soft switching is also applied to auxiliary switch. All diodes are turned off under zero current condition which causes reverse recovery problem to be alleviated. A very low current flows through auxiliary components in a very short time. Therefore, a very low conduction loss is added to the converter by an auxiliary circuit. Soft switching condition is almost independent of specifications of circuit, especially the output power. Steady‐state analysis of the proposed converter is discussed. Finally, to verify the performance and validation of the proposed converter, laboratory results for a prototype with input voltage 30 V, output voltage 240 V, output power 220 W and switching frequency 50 kHz are presented and the results are discussed. The efficiency of the prototype converter at nominal power is 96%.

A Novel Soft-Start Circuit for DC/DC Switching Regulator Using Voltage Compensation Technique

A Novel Digital Soft-Start Circuit for DC-DC Switching Regulator

A Soft-Start Circuit for Low-Dropout (LDO) Regulator Using Temperature Compensation Technique

A Novel Soft-Switching and Low-Conduction-loss Bidirectional DC-DC Converter

Soft switching characteristics of a novel and efficient DC/DC converter

Ramp-based soft-start circuit with soft-recovery for DC-DC buck converters

Soft-Start Method With Small Capacitor Charged by Pulse Current and Gain-Degeneration Error Amplifier for On-Chip DC–DC Power Converters

Soft Start-up Control Strategies of Bi-Directional Converter with High Voltage Ratio

Research on Fixed-Slope On-Chip Soft-Start Method Applied to Buck DC–DC Converter

On-chip soft-start cell for DC-DC converter

Research on digital soft start method of boost DC-DC switching power supply

A Full Soft-Switching High Step-Up DC/DC Converter with Active-Switched-Inductor and Three-Winding Coupled Inductor

A Novel Soft Switching Bidirectional Dc/Dc Converter and Design Consideration

A soft-switching post-regulator for multi-outputs dual forward dc/dc converter with tight output voltage regulation

Soft Switching High Step-Down Series-Capacitor Based Converter with Coupled-Inductor Technique

VRSPV Soft-Start Strategy and AICS Technique for Boost Converters to Improve the Start-Up Performance

A soft switching non‐isolated bidirectional DC–DC converter with improved voltage conversion ratio and minimum number of switches

Minimized start-up transient and initial inrush current of boost converter for LED lighting

A soft switched step‐up DC–DC converter using a low‐power auxiliary circuit and continuous input current

A Novel Soft Switching Bi-Directional Dc/Dc Converter

A Novel Method for Smooth Transition in Step-Up/step-down DC-DC Converter