Abstract:We study the specific catalytic effect of the catalyst on the combustion process of pulverized coal of increasing the proportion of semicoke in the mixture of semicoke and bituminous coal, and reducing the cost of blast-furnace coal injection. A combination of thermogravimetric and kinetic analyses were used to study the catalytic effect of Fe2O3 on semicoke and bituminous coal, and to improve the amount of semicoke in the mixed coal powder of bituminous coal and semicoke. Experimental results showed that Fe2O3 had a catalytic effect on both semicoke and bituminous coal, but there were differences in the catalytic stages of the same catalyst for different pulverized coal types. The addition of 2 wt % Fe2O3 to semicoke and bituminous coal each led to the ignition temperature and maximal burning rate temperature of the semicoke decreasing, indicating that the catalyst promoted the precipitation of a volatile fraction from the semicoke. The maximal burning rate temperature and burnout temperature of the bituminous coal decreased, and maximal weight loss rate increased, indicating that the catalyst promoted the combustion of the fixed carbon of bituminous coal. The optimal proportioning amount of semicoke in the mixed coal powder without the addition of a catalyst was 25%. After adding 2 wt % Fe2O3, the proportional amount of semicoke increased by 10%. The addition of the catalyst resulted in even lower activation energy for the same conversion rate. When the conversion rate was in the ranges of 0.1–0.2 and 0.5–0.7, the activation energy decreased by 22% and 26%, respectively, compared with that without a catalyst. Fe2O3 promoted the combustion of bituminous coal and semicoke. This enhanced the combustion performance of the pulverized coal mix and increased the proportion of semicoke in the mix, which has certain guiding significance in reducing the cost of blast-furnace iron making.

CATALYSIS EFFECT OF CARBIDE LIME ON VARIOUS COAL COMBUSTION

Reactivity and catalytic effect of coals during combustion: Thermogravimetric analysis

The Effect Of Limestone With Additive On Coal Combustion

The effects of an additive on clean combustion of coal and the analysis of mechanism

Non-isothermal Thermogravimetric Investigation on Mutual Effect Between Bituminite and Anthracite in Blends for Blast Furnace Injection

Effect of Chemical Compositions on Ash Fusibility Characterization of a Jincheng Anthracite During Combustion and Gasification

Research on effect of premixing pulverized coal and lime on sintering flue gas emission

The Catalytic Effect of the Na and Ca-rich Industrial Wastes on the Thermal Ignition of Coal Combustion

Study on the influence of light-burnt dolomite/Fe2O3/CeO2 composite combustion aid on the enhanced combustion characteristics of pulverized coal

Catalysis combustibility of pulverized blended coal injection

Assessment on the effect of unburned pulverized coal on the properties of coke in blast furnace

Combustion-Supporting Effect of Common Carbonous Solid Waste on Anthracites

A Thermogravimetry Investigation on the Combustibility of Coalslime Water Slurry

Experimental Investigation on Combustion Characteristics and Kinetics During Co-Firing Bituminous Coal with Ultra-Low Volatile Carbon-Based Solid Fuels

Effect of Purified Dust from CaC2 Production and Bottom Ashes/slags on Slagging Characteristic of Zhundong Coal Blend

Investigation on carbide slag catalytic effect of Mongolian bituminous coal steam gasification process

Investigation of the Characteristics of Catalysis Synergy During Co-Combustion for Coal Gasification Fine Slag with Bituminous Coal and Bamboo Residue

STUDY ON CATALYSITIC EFFECT OF INDUSTRIAL WASTE UPON PULVERIZED COAL COMBUSTION

Cascade Chain Catalysis of Coal Combustion by Na–Fe–Ca Composite Promoters from Industrial Wastes

Effect of Chemical Composition on Sintering Behavior of Jincheng Coal Ash under Gasification Atmosphere

Enhanced Combustion of Bituminous Coal and Semicoke Mixture by Ferric Oxide with Thermographic and Kinetic Analyses