Abstract:Ethylene-Tetra-Fluoro-Ethylene (ETFE) cushions are popularly used in modern civil engineering struc-tures. When a cushion vibrates in uniform flow, the surrounding fluid will be driven to move along with it. The inertia of fluid then produces an action on the cushion, which is known as the effect of added mass. This effect is usually very significant due to the light weight of these cushions. This paper proposes a new method to estimate the added mass on a close-type ETFE cushion vibrating in uniform flow with an improved accuracy compared with methods in the literature. The aerodynamic force is assumed to con-sist of pressures from uniform flow and potential flow induced by perturbation of the vibrating cushion. An analytical expression for the added mass on the cushion is then proposed based on the Laplace equa-tion and Bernoulli equation, in which the velocity of the potential fluid above the vibrating cushion is assumed to vary along the z-direction in the form of a quartic function, and the non-uniform distribution of the added mass over the enveloping membrane is also considered. The proposed method is verified by comparing the dynamic responses of the cushion considering the added mass from the Computational Structural Dynamics (CSD) module of ADINA with those in the literature and those obtained from the fluid-structure interaction (FSI) analysis. The effects of different influencing factors on the accuracy of the method, e.g., side length of the cushion, initial inner pressure, wind velocity and wind direction angle, are further studied. Results show that: (a) the proposed method to estimate the added mass is more accu-rate than those in the literature with results closer to those from the FSI analysis; (b) an increase in the side length of the cushion will lead to a more non-uniform distribution of the added mass; (c) the side length of the cushion and wind velocity have a slight effect on the accuracy of the proposed method with the maximum error within 5%; and (d) an increase in the initial inner pressure can improve the accuracy of the proposed method while the wind direction angle seems to have little influence.(c) 2023 Elsevier Ltd. All rights reserved.

Methods for Calculating Added Mass of Fabric Structures

Numerical analysis of added mass arising from fluid flow induced by vibration of three-dimensional structure

The Numerical Simulation for the Wind Fields and Wind Loads Around Spatial Structures

Estimation of Tension Force in Short Hangers Using Added Mass Method

Identification of added mass according to frequency response function test data

Investigation of Automated Geometry Modeling Process of Woven Fabrics Based on the Yarn Structures

Experimental study on the static interaction between membrane structures and air

Simulation of Heat Transfer Through Woven Fabrics Based on the Fabric Geometry Model

Numerical Investigation on Added Mass of Circle Membrane Vibrating in Still Air

Additive Mass Method for Dynamical Property of the Fixed Parts of Francis Turbine

The effects of wind-induced dynamic response by added air mass for membrane structures

Experimental Investigation on the Added Mass of Membranes Vibrating in Air

An Improved Model Updating Method by Adding Given Mass

Research on the Added Mass of Open-Type One-Way Tensioned Membrane Structure in Uniform Flow

Experimental Calculation of Added Masses for the Accurate Construction of Airship Flight Models

Numerical method for added mass of an underwater glider

Experimental Study of Added Mass of the Thin-Walled Cylinder Structure

The Added Mass of a Closed-Type Cushion in Uniform Flow

Experimental Study on Interaction Between Membrane Structures and Wind Environment

Dynamical finite element model updating methods by adding known masses

Calculation Methods of Added Mass of Parachute