Abstract:The internal flow evolution of the pump was induced with impeller movement. In various conditions, the peak load on centrifugal blade under the change of rotational speed or flow rate was also changed. It would cause an error when inertia load with a safety coefficient (that was difficult to ascertain) was applied in structure design. In order to accurately analyze the impeller stress under various conditions and improve the reliability of pump, based on a mixed flow pump model, the stress distribution characteristic was analyzed under different flow rates and rotational speeds. Based on a three-dimensional calculation model including impeller, guide blade, inlet and outlet, the three-dimension incompressible turbulence flow in the centrifugal pump was simulated by using the standard k-epsilon turbulence model. Based on the sequentially coupled simulation approach, a three-dimensional finite element model of impeller was established, and the fluid-structure interaction method of the blade load transfer was discussed. The blades pressure from flow simulation, together with inertia force acting on the blade, was used as the blade loading on solid surface. The Finite Element Method (FEM) was used to calculate the stress distribution of the blade respectively under inertia load, or fluid load, or combined load. The results showed that the blade stress changed with flow rate and rotational speed. In all cases, the maximum stress on the blade appeared on the pressure side near the hub, and the maximum static stress increased with the decreasing of the flow rate and the increasing of rotational speed. There was a big difference on the static stress when inertia load, fluid load and combined loads was applied respectively. In order to more accurately calculate the stress distribution, the structure analysis should be conducted due to combined loads. The results could provide basis for the stress analysis and structure optimization of pump.

Thermal Stress Analysis of Finite Element Method of High Pressure Blade Ring of Subcritical 600MW Turbine

Topological Structure Optimization of Finite Element based on Modal Analysis about Steam Turbine Blade

Calculation of Finite Element of Thermal Stress and Analysis of Low-cyclic Fatigue Life for Non-central Hole Rotor of 135 MW Turbine

TO CALCULATE THE STRENGTH OF TURBINE＇S DIAPHRAGM BY USING FINITE ELEMENT METHOD

Research on Boundary Conditions of T Steam Turbine Blade by Finite Element Model Analysis

INFLUENCE OF SIMPLIFYING SHAFT-SEAL GROOVES UPON THERMAL STRESS CALCULATION RESULT OF STEAM TURBINE'S ROTOR

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

FEM-based Multi-field Coupling Stress Analyses of the Cylinder-bolts System in a Gas Turbine Power Plant

THE STRUCTURAL ANALYSIS METHOD OF WIND TURBINE BLADE BASED ON MECHANICS OF COMPOSITE MATERIALS

Analysis of the Temperature and Stress Field in a Steam Turbine Bypass Valve Body

Thermal-Fluid-Solid Coupling Analysis on the Temperature and Thermal Stress Field of a Nickel-Base Superalloy Turbine Blade

Finite Element Analysis of Stress on Cross-Wavy Primary Surface Recuperator Based on Thermal-Structural Coupling Model

Computation of Stress Distribution in a Mixed Flow Pump Based on Fluid-Structure Interaction Analysis

Thermal Stress Analysis of the Solidification Process of Francis Turbine Band Casting

Stress Analysis of Francis Turbine Runners Based on FSI

A Strength Analysis and Model Investigation of the Flue Gas Turbine Blade

Dynamic Stress Analysis of Francis Turbine with Partial Load

The Influence Made by the Central Hole of Steam Turbine Rotor to Temperature and Stress Distribution of Rotor

Analysis of Dynamic Stresses in Kaplan Turbine Blades

Stress Analysis and Deformation Prediction of a Heavy Hydraulic Turbine Blade Casting During Casting and Heat Treatment

Stress analysis and deformation prediction of a heavy hydraulic turbine blade casting in heat treatment process