Abstract:Combustion of pulverized coal is experimented on the experimental furnace. Swirl burners are installed on the front wall and the back wall of the furnace. Heat output of the experimental furnace is 0.7MW. The coal is lean coal produced in Tongchuan, Shaanxi province of China. Three values of swirl intensity of swirl jet of burner are tested. Temperature distribution on the furnace walls and temperature distribution in the furnace are measured by thermal couples. Then the temperature deviation coefficient is calculated from temperature field. According to the results, temperature distribution is very complex in furnace with swirl burners. And the complexity is caused by complexity of flow field. Because cold air jets of burners cool the front wall and the back wall, the average temperature of the front wall and the back wall is lower than that of sidewalls. But the temperature deviation coefficient of the front wall and the back wall is greater than that of sidewalls. Because sidewalls receive more radiation heat flux from flames, the average temperature of sidewalls is higher than the front wall and the back wall. The temperature distribution curve on centerline of sidewall has two peak values. And in a short distance, there is a big change of temperature which value is about 200℃ on centerline of sidewall. These results must be considered in design of water-cooled wall of large boiler. The value of temperature deviation coefficient of furnace exit is about 0.04∿0.05. This value is less than that of tangential fired furnace.

Spectrum Analysis on the Character Frequency for Turbulent Flow in Tangentially Fired Furnace

OXYGEN-ENRICHED COMBUSTION IN A HORIZONTAL FURNACE AND THREE- DIMENTIONAL NUMERICAL SIMULATION TEST THEREOF

Numerical Simulation of Flow and Combustion Process in the Tangentially Fired Furnace of a 200 MW Pulverized Coal Boiler

Numerical simulation of combustion and nitrogen oxides generation process in tangentially fired furnace

THE RESEARCH OF THE CAUSE OF VELOCITY IMBALANCE IN A TANGENTIALLY-FIRED FURNACE

STUDY ON GAS-SOLID TWO-PHASE FLOW FIELD AT BURNER REGION OF SIX CORNERS TANGENTIALLY FIRED BOILER

Experimental Study of Aerodynamic Characteristics in a W-shaped Flame Boiler Equipped with a Bin and Feeder System aud Fed Tertiary Hot Air in the Boiler Furnace

Experimental study and numerical simulation on the gas-solid two-phase flow field in the furnace of a 300MW tangentially fired utility boiler

Experimental and numerical study on the flow fields in upper furnace for large scale tangentially fired boilers

Numerical and experimental investigations on the performance of a 300 MW pulverized coal furnace

Turbulent Flow Calculation in Non-Orthogonal Curvilinear Co-Ordinates and Its Measurement by PDA in a Model Furnace

EXPERIMENTAL STUDY OF JET CHARACTERISTICS OF HBC-SSA BURNER IN TANGENTIALLY FIRED FLOW FIELD

Experiments on the vorticity distribution behind the small panel

Experimental Study of Aerodynamic Characteristics in a W-shaped Flame Boiler Equipped with a Bin and Feeder System and Fed Tertiary Hot Air in the Boiler Furnace

D209 EXPERIMENTAL RESEARCH OF TEMPERATURE DISTRIBUTION IN FURNACE WITH SWIRL BURNERS

Numerical Simulations on Flow Characteristics of Flue Gas in Furnace with Four-Wall Tangential Firing

TEST STUDY ON INFLUENCE OF THE REVERSED TANGENTIAL ANGLE FOR SEPARATING OVER-FIRED AIR UPON THE AERODYNAMIC FIELD IN FURNACE

Experimental Investigations into Gas/Particle Flows in A Down-Fired Boiler: Influence of Down-Draft Secondary Air

Experimental Study on Furnace Air Flow Field of a 2000t/h Tangentially Fired Boiler

Research on Fluid Flow Characteristics in Different Load Cases in Tangentially Fired Furnaces

Combustion Characteristics of a Four-Wall Tangential Firing Pulverized Coal Furnace