Abstract:The surfaces of the hydrogen storage alloy powders (MlNi4.0Co0.6Al0.4) before and after surface treating were analyzed by X-ray photoelectron spectroscopy (XPS), electron probe micro-analysis (EPMA), inductively coupled plasma spectroscopy (ICP). It was found that a Ni-rich surface layer was produced and the specific surface area was augmented by the surface treatment with a hot 6MKOH or 6MKOH+0.02MKBH4 solution due to the preferential dissolution of Al and the etching of the hot alkaline solution. The effect of the surface treatments on the hydrogen adsorption on the alloy surface was for the first time evaluated by means of the thermal desorption spectroscopy (TDS). It was found that the surface treatments enhanced the hydrogen adsorption on the alloy surfaces and produced new adsorption states. The untreated alloy had only one hydrogen adsorption peak at about 400K. There were two hydrogen adsorption states at about 540 and 630K on the surface of the alloy treated with 6MKOH. In the case of the alloy treated with 6MKOH+0.02MKBH4 three hydrogen adsorption peaks were observed at about 390, 540 and 630K, respectively. The results of electrochemical measurements showed that the treated alloy electrodes exhibited higher exchange current density for the hydrogen electrode reaction than the untreated hydrogen alloy. After the surface treatment, the hydrogen adsorption enhancement on the treated alloy surface facilitated the hydrogen electrode reaction process on the alloy electrodes and results in good activation and low polarization resistance.

Electrochemical analysis of failed Ni-MH batteries

Electrochemical Investigations of Activation and Degradation of Hydrogen Storage Alloy Electrodes in Sealed Ni/MH Battery

Surface treatments of hydrogen storage alloy improve charge-discharge performances of Ni/MH battery

Effects of Surface Treatments of Mlni(4.0)Co(0.6)Al(0.4) Hydrogen Storage Alloy on the Activation, Charge/Discharge Cycle and Degradation of Ni/Mh Batteries

Effects of surface treatment on performances of metal hydride electrodes and Ni/MH batteries

The Electrochemical Evaluation of Ball Milled MgNi-based Hydrogen Storage Alloys

A Study of the Oxidation Determination of the Mm Hydrogen Storage Alloy and its Performance Degradation

Electrochemical Impedance Spectroscopy Study of Ni/Mh Batteries

An electrochemical investigation of mechanical alloying of MgNi-based hydrogen storage alloys

Effect of Surface Treatment on the Structure and High-Rate Dischargeability Properties of AB5-type Hydrogen Storage Alloy

Effects of sintering on the performance of hydrogen storage alloy electrode for high-power Ni/MH batteries

Changes of some capacities and failure mode of Ni/MH batteries during cycling

Influence of Annealing Treatment on Microstructure and Cycling Stability of La-Rich Ml(Nicomnal)(5) Alloy Electrode for Ni/Mh Batteries

The Effects of Partial Substitution of Mn by Cr on the Electrochemical Cycle Life of Ti-Zr-V-Mn-Ni Alloy Electrodes of a Ni/MH Battery

The effects of mechanical grinding on the hydrogen storage properties of MlNi4.7Al0.3 alloy

Corrosion and degradation behavior of Zr-based AB2 alloy electrodes during electrochemical cycling

Surface analysis for the hydrogen storage alloy and electrocatalytic activity of MH electrodes

Electrochemical properties and Rietveld analysis of Multicomponent MlβMm1-β (NiCoMnTi)5 hydrogen storage alloys (2) Rietveld analysis

Surface treatment for hydrogen storage alloy of nickel/metal hydride battery

Hydrogen adsorption on hydrogen storage alloy surface and electrochemical performances of the MlNi4.0Co0.6Al0.4 alloy electrodes before and after surface treatment

Surface analysis, hydrogen adsorption and electrochemical performance of alkali-reduce treated hydrogen storage alloy