Study on modified models for inelastic deformation of reinforced concrete beam-column joints

杨红,莫林辉,陈进可,傅剑平

DOI: https://doi.org/10.14006/j.jzjgxb.2014.03.018

2014-01-01

Abstract:Inelastic deformations of reinforced concrete beam-column joint consist of longitudinal rebar slippage at beam end and shear deformation of joint,which affects the elasto-plastic mechanical characteristics of beam-column subassemblage specimen obviously. The Modeling methods of inelastic deformation of joint will directly influence the rationality of structural response analysis results under strong earthquake excitations. On the basis of fiber model,the modeling method of combining a zero-length section element at the ends of the nonlinear beam-column element could conveniently and effectively simulate the inelastic deformation of joint. Based on the significance analysis and nonlinear fitting results of the measured experimental data of 39 reinforced concrete interior joints and 12 exterior joints,a constitutive model of σ-sslip-shearwhich could simulate the effect of longitudinal rebar slippage at beam end and joint shear deformation simultaneously was proposed. Four beam-column subassemblage tests with different joint parameters were used as examples to verify the proposed modeling method. The results show that the calculated results of capacity and energy dissipation behavior of beam-column subassemblage is much higher if inelastic deformation of jointis ignored. Inelastic mechanical characteristics of beam-column subassemblage could be simulated more accurately when inelastic deformation of joint is considered,and the deformation characteristics that the plastic deformations will transfer from ends of element to the joint while the inelastic deformation of joint is increasing could also be simulated.