Abstract:At sufficiently small spark gap ( d gap =0.64 mm) and at sub-atmospheric pressure ( p = 0.3 atm), a numerical simulation by Chen et al. (2023) reported a flow-facilitated ignition (FFI) phenomenon in an imposed uniform flow perpendicular to a pair of electrodes, where a constant ignition energy (E ig =1.24 mJ) cannot ignite the hydrogen/air mixture at an equivalence ratio φ =0.4 with small Lewis number Le ≈0.43<<1 in quiescence but ignition is successful in flowing conditions. This implied that the occurrence of FFI was mainly due to heat losses regardless of Le in contradiction with previous turbulence-facilitated ignition results. To test FFI, a well-controlled ignition experiment at d gap =0.6 mm using the same simulation flow-electrode concept via a uniform flow setup resided in a large pressure-controlled chamber with optical access is conducted for three targeted mixtures having Le ≈0.43<<1 (H 2 /air at φ =0.4), Le ≈2.3>>1 (H 2 /air at φ =5.1), and Le ≈0.95∼1 ((80%NH 3 +20%H 2 )/air at φ =1). Various E ig =0.2∼250 mJ of high accuracy are applied to measure minimum ignition energies (MIE) at 50% ignitability under static and flowing conditions with an inlet flow velocity ( U in =0–10 m/s) at p = 0.3 atm and/or 1 atm. Experimental results show no FFI for Le ≈0.43<<1 and Le ≈0.95∼1 cases even at p = 0.3 atm, because values of MIE increase gradually with increasing U in . However, FFI does occur for Le ≈2.3>>1 case, since E ig =250 mJ cannot ignite static mixture at p = 1 atm and MIE decreases drastically from 151.8 mJ at U in =1 m/s to 30.1 mJ at U in =4 m/s. These results provide important information of the effects of uniform flow on electrode-spark (forced) ignition of premixed flames, revealing two key points: (i) Heat losses alone cannot lead to FFI, because FFI does not occur at Le ∼1 and Le <<1 cases even at p = 0.3 atm. (ii) FFI only occurs at sufficiently large Le >>1 and sufficiently small d gap .

An Experimental Study on Central Charge of FAE Based on Single Ignition

Experimental Study of Influence on FAE Fuel Dispersion and Explosion with Inducers-contained Central Charge

Experimental Study on Primary Initiation of New Composite FAE Fuel

A Study on Self-Harmony of Dispersion and Initiation of Solid Mixture FAE

Experimental study on explosion effect during single ignition of fuel air explosive

Experimental Study on Unconfined Volume Explosion Effects of Low-mass New Fuel Air Explosives

Experimental Study on Single Ignition of Solid and Liquid FAE

Experimental Study on Revulsive Effect of Oxidizer on Single-event FAE

Optimization Design of Fuel Charged in Solid Single-event FAE

An Experimental Investigation of Optimizing Control of Compound Charge Compression Ignition(CCCI)Combustion in an Engine Fueled with DME

Development of a Spark-Ignited Direct Injection Flexible Fuel Engine for Gasoline and Alcohol Fuels

The Experimental Investigation on Launching Safety of FAE Explosive Charge

An Experimental Study to Control Homogeneous Charge Compression Ignition Combustion and Emission Using Real-Time Fuel Design

Experimental Study on Single Ignition of Multi-Component Fuel Mixture

High-Temperature Ignition Delay Times and Kinetic Study of Furan

Shock tube and comprehensive kinetic modeling study of ammonia/diethyl ether (DEE) mixtures

A Composite-Fuel Additive Design Method for N-Decane Low-Temperature Ignition Enhancement

Experimental And Numerical Study On Auto-Ignition And Combustion Of Homogeneous Charge Compression Ignition Fueled With Dimethylether

Performances and Combustion Characteristics of a Spark-Ignited Direct-Injection Flexible Fuel Engine

An experimental investigation on a flow-facilitated ignition at reduced and normal pressures for small, near-unity and large Lewis number of hydrogen/air and hydrogen/ammonia/air mixtures

Combustion and Emission Characteristics of Direct Injection Compression Ignition Engine Fueled with Full Distillation Fuel (FDF)