An experimental investigation on a flow-facilitated ignition at reduced and normal pressures for small, near-unity and large Lewis number of hydrogen/air and hydrogen/ammonia/air mixtures

Van Tinh Mai,Shenqyang (Steven) Shy

DOI: https://doi.org/10.1016/j.combustflame.2024.113746

IF: 4.4

2024-09-25

Combustion and Flame

Abstract:At sufficiently small spark gap ( d gap =0.64 mm) and at sub-atmospheric pressure ( p = 0.3 atm), a numerical simulation by Chen et al. (2023) reported a flow-facilitated ignition (FFI) phenomenon in an imposed uniform flow perpendicular to a pair of electrodes, where a constant ignition energy (E ig =1.24 mJ) cannot ignite the hydrogen/air mixture at an equivalence ratio φ =0.4 with small Lewis number Le ≈0.43<<1 in quiescence but ignition is successful in flowing conditions. This implied that the occurrence of FFI was mainly due to heat losses regardless of Le in contradiction with previous turbulence-facilitated ignition results. To test FFI, a well-controlled ignition experiment at d gap =0.6 mm using the same simulation flow-electrode concept via a uniform flow setup resided in a large pressure-controlled chamber with optical access is conducted for three targeted mixtures having Le ≈0.43<<1 (H 2 /air at φ =0.4), Le ≈2.3>>1 (H 2 /air at φ =5.1), and Le ≈0.95∼1 ((80%NH 3 +20%H 2 )/air at φ =1). Various E ig =0.2∼250 mJ of high accuracy are applied to measure minimum ignition energies (MIE) at 50% ignitability under static and flowing conditions with an inlet flow velocity ( U in =0–10 m/s) at p = 0.3 atm and/or 1 atm. Experimental results show no FFI for Le ≈0.43<<1 and Le ≈0.95∼1 cases even at p = 0.3 atm, because values of MIE increase gradually with increasing U in . However, FFI does occur for Le ≈2.3>>1 case, since E ig =250 mJ cannot ignite static mixture at p = 1 atm and MIE decreases drastically from 151.8 mJ at U in =1 m/s to 30.1 mJ at U in =4 m/s. These results provide important information of the effects of uniform flow on electrode-spark (forced) ignition of premixed flames, revealing two key points: (i) Heat losses alone cannot lead to FFI, because FFI does not occur at Le ∼1 and Le <<1 cases even at p = 0.3 atm. (ii) FFI only occurs at sufficiently large Le >>1 and sufficiently small d gap .

energy & fuels,engineering, chemical, mechanical,thermodynamics, multidisciplinary