Abstract:Introduction: The objective of this research was to evaluate the correlation between 3-dimensional (3D) lip vermilion (LV) morphology and skeletal patterns as well as incisor measurements in young Chinese adults. Methods: In all, 240 young adults were enrolled; these included 80 patients each with skeletal Class I, Class II, and Class III malocclusions, respectively. Each sagittal skeletal pattern included 40 male and 40 female subjects. Twenty-two 3D LV measurements were obtained from 3D facial scans. Skeletal and incisor measurements were evaluated on lateral cephalograms. Correlation and regression analysis were performed between soft and hard tissue measurements. Results: Six of 22 LV measurements showed significant differences between male and female subjects. The 3D LV morphology showed significant differences with respect to different skeletal patterns and sex. Adults with skeletal Class III malocclusion tended to have thinner upper vermilion and fuller lower vermilion than subjects with skeletal Class II and III malocclusion. The mandibular plane angle negatively correlated with the upper-lower vermilion midsagittal curve length and surface area ratio in adults with skeletal Class I and II malocclusion, yet the vertical facial skeletal type showed no correlation in adults with skeletal Class III malocclusion. The vermilion angle, central bow angle, vermilion height, vermilion midsagittal curve length, vermilion height and width ratio, and vermilion surface area showed a significant correlation with incisor measurements. Regression analysis found that the ANB angle was an important factor affecting the upper and lower vermilion midsagittal curve length and surface area ratio. Further, the vermilion height and height and width ratio were closely correlated with the interincisal (U1/L1) angle, whereas the central bow angle was closely correlated with the maxillary incisor torque. Conclusions: Most LV morphology variables were correlated to skeletal patterns and incisor measurements. Skeletal Class III malocclusion showed significant differences in vermilion morphology. Both the sagittal and vertical skeletal pattern have effects on vermilion proportion. The incisor torque was closely correlated to vermilion shape and central bow angle and might influence the vermilion esthetics. However, the proportion of the upper and lower vermilion was mainly affected by the ANB angle.

Morphological Study of the Lateral Inferior Arc Curve of Mandible

Study of the relationship between facial anatomical marking points and occlusal vertical dimension

Relationship between the mandibular curve of Spee and the maxillary compensating curve with dentoskeletal morphology : A cross-sectional study in Chinese young adults with normal occlusion

[Three Dimensional CT for Measuring Mandibles Morphology in 54 Normal Chinese Adults].

Analysis of Correlation of 3-Dimensional Lip Vermilion Morphology and Dentoskeletal Forms in Young Chinese Adults on the Basis of Sex and Skeletal Patterns.

c-Jun enhancement of cyclic adenosine 3',5'-monophosphate response element-dependent transcription induced by transforming growth factor-beta is independent of c-Jun binding to DNA.

A Cone Beam Computed Tomography Study Based on Three-Dimensional Cephalometric Analysis of Relationships Between the Lip-Line and Jaw Deformity

Study on the correlation between the structure of TMJ and vertical craniofaciai pattern, occlusion in Class Ⅱ1 Children

Cephalometric analysis of chin soft tissue on Angle Class Ⅱ1 malocclusion with different vertical skeletal craniofacial patterns

Relationship between alveolar-bone morphology at the mandibular incisors and their inclination in adults with low-angle, skeletal class III malocclusion—A retrospective CBCT study

Archform Comparisons Between Skeletal Class Ii and Iii Malocclusions

Cone-beam Computed Tomography-based Three-Dimensional Cephalometric Analysis of Mandible Symmetry and the Occlusal Plane of Adult Patients with High-Angle Skeletal Class III Malocclusion and Jaw Deformity

Study of the relationship between the long axis of the mandibular symphysis and the lower incisors in natural dentition based on cephalometric analysis

Preliminary comparison of three-dimensional reconstructed palatal morphology in subjects with different sagittal and vertical patterns

Three-dimensional evaluation of the relationship between dental and basal arch forms in skeletal classⅡmalocclu-sions

Condylar Lateral Movements in Patients with Mandibular Deviation

Comparative evaluation of buccolingual inclination of molars in low-angle cases and high-angle cases using manual technique- A pilot study

Relationship Between Dental Arch Anomalies and Craniofacial Characteristics in Patients with Deviated Mandible

The Lower Bow-Shaped Curve As a Novel Reference Frame to Determine the Lateral Limit of the Maxillary Anterior Arch for Smile Esthetics.

A retrospective study of coronoid process morphology in patients with long-face morphology based on CBCT

Morphological Analysis of the Anatomical Mandibular Lingual Concavity Using Cone Beam Computed Tomography Scans in East Asian Population-A Retrospective Study