Abstract:The Journal of Strain Analysis for Engineering Design, Ahead of Print. 1060-H112 aluminum alloy with high ductility is widely used in industrial engineering. The study of its dynamic mechanical behavior has theoretical and engineering application value. In this paper, quasi-static tensile tests from room temperature to 250°C and high strain rate compression tests were conducted using a universal material testing machine and a Hopkinson compression bar. By using a hybrid test-numerical simulation method, a modified Johnson-Cook (MJC) strength model and Cockcroft-Latham (C-L) fracture criterion parameters were calibrated. Subsequently, Taylor impact tests were performed on 1060-H112 aluminum alloy specimens with a diameter of 12.66 mm and a length of 50.64 mm in the range of 176.3–483.03 m/s. Upsetting and tensile tearing were observed in the tests. A 12.68 mm diameter blunt nosed projectile impact test on 2 mm 1060-H112 aluminum alloy plate was also conducted with a light gas gun system, and the speed related parameters and failure modes were obtained. Finally, a three-dimensional model corresponding to the test was established in ABAQUS/Explicit finite element simulation software, and the failure modes of the Taylor rod and the velocity parameters and failure modes of the target impact test were predicted. The results show that the MJC strength model and the C-L fracture criterion can predict the experimental results of the two tests accurately. It shows that the MJC strength model and C-L fracture criterion have high accuracy, and they will play an important role in the application of 1060-H112 aluminum alloy in industrial engineering.

An Experimental Investigation into Ductile-Brittle Transition of Pure Aluminum Sheet Constrained by Double Interface

Ductile to Brittle Transition of Pure Al Sheet Constrained by Strength Mismatched Parallel Bi-Interface

Ductile to Brittle Transition of Pure Al Sheet Constrained by Parallel Bi-Interface with High Strength Al Alloy

Ductile–brittle transition of pure Al-interlayer sandwiched by high strength Al alloy

Ductile to brittle transition of inter pure AL sheet constrained by parallel bi-interface with high strength Al alloy

Numerical Analysis of the Crack-Tip Stress Field in Pure Aluminum Sheet Constrained by Interfaces

Effect of LY12 Alloy Constraint on the Ductile to Brittle Transition of Al Interlayer

Experimental and numerical investigations into the ductile fracture during the forming of flat-rolled 5083-O aluminum alloy sheet

Study on Fatigue Crack Propagation and Extrinsic Toughening of an Al–Li Alloy

Failure analysis of single-point butt clinched joint with dissimilar aluminium alloy sheets

Numerical Simulation of Ductile Fracture Behavior for Aluminum Alloy Sheet under Cyclic Plastic Deformation

Fatigue Crack Propagation along Explosive Bonded Al/LY12 Interface

Anisotropic Behavior in Plasticity and Ductile Fracture of an Aluminum Alloy

Influence of ductile damage on the bending behaviour of aluminium alloy thin sheets

STUDY ON FATIGUE BEHAVIOR OF METAL/METAL LAMINATES

Modeling of the Ductile Fracture During the Sheet Forming of Aluminum Alloy Considering Non-Associated Constitutive Characteristic

Deformation response research on aluminum sheets with different central pre-cracked defects under quasi-static hydraulic pressure loading

Experimental Investigation of Thickness Effects on Mixed-mode I/II Fracture of an Aluminum Alloy

Effect of stress triaxiality and normalized Lode angle on ductile fracture of aluminum 2139-T8

Study of dynamic mechanical behavior of 1060-H112 aluminum alloy: Experimental and numerical simulation

Influences of heat-treating process on ductile fracture mechanism under mixed mode loadings